Replacements and Installations

Installing the WORM PULLEY and MECHANISM BELT

FAN BELT

MECHANISM BELT

 

A091_4015BCA

A091_4015BA

Important

When installing the FAN and MECHANISM BELTS, install the MECHANISM BELT on the small MOTOR PULLEY, and the FAN BELT on the large MOTOR PULLEY.

[1]Do the replacement procedure for the WORM PULLEY and MECHANISM BELT in reverse order.

Replacing the THERMAL FUSE ASSEMBLY

Warning

Dangerous Voltage

[1]Disconnect the main power.

[2]Do the replacement procedure for the LOWER HOUSING ASSEMBLY.

[3]Cut and remove the necessary WIRE TIES.

[4]Remove the black wire from the THERMAL FUSE ASSEMBLY on the POWER SWITCH.

[5]Remove the gray wire from the THERMAL FUSE ASSEMBLY from the POWER CORD.

[6]Loosen the Torx SCREW on the PREHEAT DUCT approximately half way.

[7]Pull the THERMAL FUSE ASSEMBLY out of hole of the LOWER LIGHT BAFFLE ASSEMBLY.

SM4530-1 – 30APR96

9

Page 9
Image 9
Kodak KKE PLUS, KKA, JAMT, J-E PLUS, BR Installing the Worm Pulley and Mechanism Belt, Replacing the Thermal Fuse Assembly