Electrolux AG22H42STA manual Install Mulcher Plate, Install Seat

Page 9

INSTALL SEAT

Adjust seat before tightening adjustment knob.

1.Remove adjustment knob and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor.

2.Pivot seat upward and remove from the cardboard packing. Remove the cardboard packing and discard.

3.Place seat on seat pan so head of shoulder bolts are positioned over the large slotted holes in pan.

4.Push down on seat to engage shoulder bolts in slots and pull seat towards rear of tractor.

5.Pivot seat and pan forward and as- semble adjustment knob and flat washer loosely. Do not tighten.

6.Lower seat into operating position and sit in seat.

7.Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.

8.Get off seat without moving its ad- justed position.

9.Raise seat and tighten adjustment knob securely.

Seat

Seat Pan

02617 Shoulder

Bolts

Flat Washer

02615

Adjustment Knob

NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.

TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls)

1.Press lift lever plunger and raise attachment lift lever to its highest po- sition.

2.Release parking brake by depressing clutch/brake pedal.

3.Place freewheel control in “trans-

mission disengaged” position (See “TO TRANSPORT” in the Operation section of this manual).

4.Roll tractor forward off skid.

5.Remove banding holding deflector shield up against tractor.

TO DRIVE TRACTOR OFF SKID (See Operation section for location and function of controls)

WARNING: Before starting, read, un- derstand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

1.Be sure all the above assembly steps have been completed.

2.Check engine oil level and fill fuel tank with gasoline.

3.Place freewheel control in "trans- mission engaged" position. (See “TO TRANSPORT” in the Operation section of this manual).

4.Sit on seat in operating position, depress clutch/brake pedal and set the parking brake.

5.Place motion control lever in neutral

(N)position.

6.Press lift lever plunger and raise attachment lift lever to its highest posi- tion.

7.Start the engine. After engine has started, move throttle control to idle position.

8.Release parking brake.

9.Slowly move the motion control lever forward and slowly drive tractor off skid.

10.Apply brake to stop tractor, set parking brake and place motion control lever in neutral position.

11.Turn ignition key to "STOP" position. Continue with the instructions that follow.

INSTALL MULCHER PLATE

(If previously removed)

1.Raise and hold deflector shield in upright position.

2.Place front of mulcher plate over front of mower deck opening and slide into place, as shown.

3.Hook front latch into hole on front of mower deck.

4.Hook rear latch into hole on back of

mower deck.

CAUTION: Do not remove deflector shield from mower.

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Lawn Tractor Warranty Table of ContentsSafety Rules General OperationII. Slope Operation IV. Service III. ChildrenDo not Safety Rules Product Specifications Customer ResponsibilitiesAPI-SG-SL Steering Wheel Unassembled PartsTools Required for Assembly ASSEMBLY/PRE-OPERATIONHOW to SET UP Your Tractor To Remove Tractor from CartonInstall Seat Install Mulcher PlateAssemble Gauge Wheels to Mower Deck To Convert to Bagging or DischargingCheck Tire Pressure Check Deck LevelnessOperation Know Your Tractor Height Adjustment Knob Used toTo USE Choke Control HOW to USE Your TractorTo Operate on Hills To Operate MowerTo Start Engine Before Starting the EnginePurge Transmission Mulching Mowing Tips Mowing TipsMaintenance General Recommendations Lubrication ChartBefore Each USE Tractor Transaxle Cooling EngineTransaxle Pump Fluid BeltsAIR Filter CleaningService and Adjustments To Install MowerTo Remove Mower SIDE-TO-SIDE Adjustment To Level Mower HousingBelt Installation To Replace Mower Blade Drive BeltTo Adjust Brake To Check and Adjust BrakeTo Check Brake To Replace Motion Drive BeltTo Adjust Steering Wheel ALIGN- Ment Transaxle Motion Control LE- VER Neutral AdjustmentTransmission Removal Replacement Front Wheel TOE-IN/CAMBERTo Adjust Throttle Control Cable Replacing BatteryTo Adjust Carburetor To Replace Headlight BulbBattery StorageOther Problem Cause Correction Troubleshooting ChartExcessive Poor grass Suggested Guide for Sighting Slopes for Safe Operation

AG22H42STA specifications

The Electrolux AG22H42STA is an innovative and versatile appliance designed for modern households, offering a blend of power, efficiency, and convenience. This upright vacuum cleaner is engineered to handle a variety of surfaces, making it an ideal choice for both carpets and hard floors.

One of the standout features of the Electrolux AG22H42STA is its powerful motor, providing robust suction capabilities that effectively lift dirt, dust, and pet hair from deep within carpets and upholstery. This ensures a thorough clean, making it particularly suitable for homes with pets or heavy foot traffic.

The vacuum's multi-surface cleaning technology is another highlight, allowing users to transition seamlessly from carpets to hard floors without needing to change attachments. This adaptability makes the AG22H42STA a practical solution for maintaining a clean home, regardless of the flooring types present.

Ergonomics has been a key focus in the design of the AG22H42STA. Its lightweight structure and easy maneuverability reduce strain on the user, making cleaning less of a chore. Additionally, it features a comfortable handle and convenient controls that enable quick adjustments on the go, enhancing the user experience.

Another noteworthy characteristic is the vacuum's advanced filtration system, which captures allergens and fine dust particles, contributing to improved indoor air quality. This is particularly beneficial for allergy sufferers, as it minimizes the presence of environmental irritants.

The AG22H42STA is designed for user convenience, featuring a large-capacity dust container that reduces the frequency of emptying and maintenance. Moreover, the bagless design streamlines cleaning, making it easier to dispose of collected debris.

In terms of aesthetics, the vacuum’s sleek, modern look integrates well into any home setting. The design not only emphasizes functionality but also aesthetics, making it a stylish addition to cleaning arsenal.

Overall, the Electrolux AG22H42STA embodies a commitment to high performance, reliability, and user-friendly features, making it a noteworthy option for anyone seeking an efficient cleaning solution. Whether tackling messes on carpets or hard surfaces, this vacuum is engineered to meet the demands of today’s busy lifestyles while providing a high level of cleanliness.
Top Page Image Contents