Ac voltage, installation and rack mounting

ac voltage, installation and rack mounting	3

115v – 230v AC Voltage

110–120V is the typical AC voltage in North America; most other countries supply 220–240V. The 5250 v.2 is internally wired for either 115V or 230V, according to where you purchased it and the voltage that is marked on its carton. If you plug a unit that is wired for 115V into a 230V outlet it can damage it.

Note: Only a qualified repair technician should make AC voltage conversions. For your own safety, please do not attempt this yourself!

Installation and Ventilation Requirements

Install your Model 5250 v.2 away from heat sources such as heating ducts, radiators, or other heat producing components. Always position it horizontally.

Observe the following ventilation guidelines when installing the Model 5250 v.2 in an equipment rack or any other enclosed space:

You should never install the Model 5250 v.2 in an unventilated equipment cabinet or compartment because hot air will not exhaust adequately to prevent overheating. Air won’t often circulate adequately in a cabinet or enclosure whose front and back sides are open; pockets of intense heat can still develop around any heat-producing equipment. Therefore, a ventilation fan is highly recommended. Allow a few inches of empty space on each side and above the unit and try to avoid crowding or stacking the Model 5250 v.2 tightly between other components. A ventilation fan is also recommended where other equipment must be mounted close to the Model 5250 v.2.

Do not place the unit on carpeting or any other material that could obstruct air flow into the ventilation holes in its chassis bottom.

Rack Mounting

The Model 5250 v.2 occupies four rack spaces in a standard 19” equipment rack.

For rack mounting, you must use the Parasound RMK44 rack mounting kit (purchased separately). We recommend that you use the 8 insulated shoulder washers with the four mounting bolts which are included with the RMK44. This eliminates metal-to-metal contact between the Model 5250 v.2 chassis, the equipment rack, and the other components in the rack. Position these washers on both sides so they “sandwich” the front panel before the mounting bolts are screwed into the rack rail.