4Rear Panel Connections and Controls
Connection Precautions
Disconnect the AC cord before making or changing any input, trigger, or speaker wire connections. Make sure there is no strain or tension on any wires that could cause them to pull loose
Audio In Jacks
Connect the cables from your preamplifier or
We suggest using channels 1 and 2 for your left front (L) and right front (R) channels. This will assure correct operation of the Turn On Options audio sensing, should you choose to use it. Here is why:
•When you listen to a stereo source your surround controller will have audio signals only at its left and right channel output jacks. The other channels won’t receive an audio signal for the Turn On Options circuit to sense.
•Even if you always listen in a surround mode, the sub, center and surround channel sound levels aren’t high enough, on a consistent basis, for the Turn On Options audio sensing.
5.1 Channel Connections
We recommend these connections: |
| |
| 5250 v.2 Input jack | 5250 v.2 Speaker Terminal |
| Connects to Surround Controller’s Output: | Connects to: |
|
|
|
Channel 1 | Left or L channel | Left front speaker |
|
|
|
Channel 2 | Right or R channel | Right front speaker |
|
|
|
Channel 3 | Center, or Ctr channel | Center speaker |
|
|
|
Channel 4 | RS or Right surround channel | Right surround speaker |
|
|
|
Channel 5 | LS or Left Surround channel | Left surround speaker |
|
|
|