REMOVETHEINLETRESTRICTOR3. While holding the inlet cover open,
Aninletrestrictorisusedwhenusing | align | the | arrows and insert | the vac- | |
yourunitasablowerThisrestrictoris. | uum | tube | into the opening. | Twist the | |
notusedduringvacuumuseandmust | tube clockwise until it is seated. A | ||||
second arrow on the vacuum tube | |||||
beremovedduringassemblyforvacu- | |||||
|
|
|
| ||
umuse. | will align | with the arrow on the unit | |||
NOTE:Besuretokeeptheinletre- | once the tube is twisted completely | ||||
into | place. |
| |||
strictorforusingyourunitasablower. |
|
|
|
| |
1.Ensureunitisstoppedandextension |
| Align arrows on tube & unit | |||
cordisunplugged. |
|
|
|
| |
2.Opentheinletcoverbyinsertingthe tipofascrewdriverintothelatch areaonthevacuuminletcover. Gentlytilthandleofscrewdriverto- wardthefrontoftheunitwhilepull- 4. To attach the lower vacuum tube to
inguponthevacuuminletcover | the | upper | vacuum | tube, | first | align | ||
withyourotherhand. | the | arrows | on the two tubes. | Then, | ||||
| _.. LatchArea | press the | two | tubes | together | until | ||
Impeller | _ "_ | the | lower | tube | is securely | seated in | ||
|
| the upper tube (about 3 inches). | ||||||
|
|
| Upper | Tube |
|
|
| |
VacuumInletCover
Lower Tube
| ATTACH | THE COLLECTION | BAG | ||||
3.Turntheinletrestrictorcounterclock- |
|
|
|
|
|
| |
wiseandremoveitfromtheunitDo. | Slide the opening of the collection bag | ||||||
over | the | blower outlet. | Pull the | velcro | |||
notclosetheinletdoorYouwillnext. | strap | tightly | through | the buckle | and se- | ||
attachthevacuumtubes. | cure | to the | velcro tabs. |
|
| ||
| NOTE: Make sure the velcro strap is | ||||||
| located on the blower outlet as shown | ||||||
| below. Also, make sure the zipper on | ||||||
| the bag is completely closed. |
| |||||
Vrte°toomver |
|
|
|
| |||
_rleettricto Z' _[_"_" | Velcro Strap _ | / | i |
| |||
|
|
|
|
|
|
| |
ATTACHING THE VACUUM TUBES | Coll_ |
| _.._ |
|
|
| |
There are 2 vacuum tubes, an upper |
|
|
|
| |||
|
|
|
|
|
|
| |
and lower tube. The upper tube is cut straight on both ends and attaches to the blower unit. The lower tube at-
taches to the upper tube, and has an angled end that you point toward the ground during vacuum use.
1.Ensure unit is stopped and exten- sion cord is unplugged.
2.Locate the arrows on the upper vac- uum tube and on the vacuum inlet
area of the unit.
Upper Vacuum Tube
Bag | _ | Blower Outlet |
ADJUSTING THE SHOULDER STRAP
ON THE COLLECTION BAG
1.Carefully loop the shoulder strap
through the buckle as shown in the illustration below.
Last in t_