Craftsman 247.79452 LOG Splitter, Start the engine and let it run until the fuel lines

Page 17

Prepare your log splitter for storage at the end of the season or if the log splitter will not be used for 30 days or more.

WARNING: Never store machine with fuel

in the fuel tank inside of building where fumes may reach an open flame or spark, or where ignitionsources are present such as hot water and space heaters, furnaces, clothes dryers, stoves, electric motors, etc.

NOTE: A yearly check-up by your local Sears service center is a good way to make certain your log splitter willprovide maximum performance for the next

season.

LOG SPLITTER

Clean the log splitter thoroughly.

Wipe unit with an oiled rag to prevent rust, especially wedge and beam.

ENGINE

IMPORTANT: It is importantto prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel filter, fuel hose, or tank during storage. Also, experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

Drain the fuel tank.

Start the engine and let it run until the fuel lines

and carburetor are empty.

Drain carburetor by pressing upward on bowl drain which is located below the carburetor.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may

Occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an aoceptab/e alternative in

mln#771zingthe formation of fuel gum deposits during storage.

Add stabilizer to gasoline in fuel tank or storage container.

Always follow the mix ratio found on stabilizer container.

Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor.

Do not drain the gas tank and carburetor if using fuel stabilizer. Drain all the oil from the

crankcase (this should be done after the engine has been operated and is still warm) and refill the crankcase with fresh oil.

If you have drained the fuel tank, protect the inside of the engine as follows.

Remove spark plug, pour approximately 1/2 ounce (approximately one tablespoon) of engine oil into cylinder and crank slowlyto distribute oil.

Replace spark plug.

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if it starts to rust. Rust and/or dirt in the gasoline will cause problems. Store unit in a clean, dry area. Do not store next to corrosive materials, such as fertilizer.

NOTE: If storingin an unventilated or metal storage shed, be certain to rustproof the equipment by coating

with a light oil or silicone.

17

Image 17
Contents Log Splitter Espanbl Model NumberDexron Spark Plug Gap ChampionTraining TowingTo the rules for safe operation This Manual Injury to Yourself or othersOtherwise not alert to use your log splitter PreparationOperation Important Information Customer ResponsibilitiesTailight Kit NeverSetting Up Log Splitter Disconnecting Spark PlugTools and Other Items Required Unpacking from CrateBeam Assembly Final AssemblyTire Pressure Spring Lever Jack StandMeets Ansi Safety Requirements Reservoir Fill-Up Engine bore damage due to inadequate lubricationStopping Engine Starting EngineRaising and Lowering Beam ControlOperating Position Transporting the Log SplitterBefore Each Use Operating the Log SplitterBeam And Splitting Wedge General RecommendationsHydraulic Fluid Hex Bolt Engine MaintenanceCarburetor TiresEngine Speed Flexible Pump CouplingWasher LockHex NutStart the engine and let it run until the fuel lines LOG SplitterProblem Possible Cause Corrective Action Engine failsto start Dirty air cleaner Or repairs beyond the minor adjustments listed aboveNot in on position Will not splitlogs82 ?8 Craftsman 9 H.P. Log Splitter ModelB627 333 Craftsman 9 H.P, Log Splitter Model 173 151 127 Governor Lever Clamp 650880Valve Cover 35377Air Cleaner Cover 35881 Air Cleaner Filter2o3 204640109 631970632164 Carburetor IncL 184 of EngineKey Part No KeySears