uprightpositionReleasespring.lever. See
Figure 4,
Spring
Lever
Jack Stand
Lower the beam assembly to its horizontal position. Make certain the beam is locked securely with the horizontal beam lock. See Figure 5.
Pull the log splitter off the pallet.
Figure 4
Cut the two straps from around the reservoir tank assembly,
Remove the lag screw and washer which secures the beam assembly to the bottom of the
crate.
Final Assembly
Tire Pressure
The tires may have been
•Check tire pressure regularly. The tire pressure should not exceed 30 p.s.i.
Preparing Log Splitter
Place the logsplitter on a firm, level surface. Lubricate the beam area where the splitting wedge will slide with engine oil (do not use
grease). Make certain to oil both front and back of the beam face.
Fill the reservoir with hydraulic fluid following instructions on page 10.
Check engine oil level and refill, if necessary. Follow instructions for oil
Beam
Assembly
Beam Lock
Figure 5