KNOW YOUR BRUSHCUTTER ATTACHMENT
READ THIS OPERATOR'SMANUALAND SAFETY RULES BEFORE OPERATING YOUR BRUSHCUTTER ATTACHMENT. Compare the illustrations with your unit to familiar-
ize yourself with the location of various controls and adjustments, Save this manual for future reference,
e
ocking Lever
Hanger | _b, | Gearbox _ |
| Blade Shield "__ | Blade |
BLADE
The BLADE is designed for cutting grass, weeds, and brush upto 1/2 inch in diameter,
OPERATING THE COUPLER
Your powerhead is equipped with a coupler which enables optional attach- ments to be installed. The optional at-
tachments | are: |
Edger | C944,511570 |
Cultivator | C944.511580 |
Blower | C944,511600 |
WARNING: Always disconnect powerhead spark plug before remov- ing or installing attachments,
REMOVING ATTACHMENT
CAUTION: When removing or instal-
ling attachments, place the powerhead and attachment on a flat surface for
stability,
1, Loosen the coupler by turning the knob counterclockwise.
UpperTube
Coupler
Lower
Attachment
TIGHTEN Knob
LOCKING LEVER
The LOCKING LEVER is used to prevent the blade shaft from turning during blade replacement,
2, Press and hold the locking/release button,
Locking/Release Button
/
UpperTube
Lower Attachment
3, While securely holding the upper tube, pull the attachment straight out of the coupler,
INSTALLING ATTACHMENT
1, Remove the tube cap from the at- tachment (if present)and discard.
2, Position locking/release button of attachment into guide recess of upper tube coupler.
Coupler Primary Hole
uide Recess
Upper Locking/ Attachment
Tube Release
Button
3, Push the attachment into the cou- pler until the locking/release button snaps into the primary hole,