•WHEN BLADE THRUST OCCURS - Blade Thrust can occur without
warning if the blade snags, stalls, or
binds. This is more likely to occur in areas where it is difficult to see the
material being cut. By using the unit properly, the occurrence of blade thrust will be reduced and the opera- tor will be less likely to lose control.
•Cut only grass, weeds, and woody
brush up to 1/2 inch (1 cm) in diameter with weed blade. Do not let blade con-
tact material it cannot cut such as stumps, rocks, fences, metal, etc., or clusters of hard, woody brush with a diameter greater than 1/2 inch (1 cm).
•Use a sharp blade. A dull blade is more likely to snag and thrust.
•Cut only at full throttle. The blade will have maximum cutting power and is less likely to bind or stall.
•"Feed" the blade deliberately and not too rapidly. The blade can thrust away if it is fed too rapidly.
•Cut only from your left to your right. Swinging unit in the same direction as blade spin increases cutting action.
•Use the shoulder strap and keep a firm grip on the unit with both hands. A properly adjusted shoulder strap will support the weight of the unit, freeing your arms and hands to con- trol and guide the cutting motion.
•Keep feet comfortably spread apart and braced for a possible sudden, rapid thrust of unit. Do not overreach. Keep firm footing and balance.
•Keep blade below waist level. It will be easier to maintain control of unit.
•Do not raise the engine above your waist as the blade can come danger- ously close to your body.
•Do not swing the unit with such force
that you are in danger of losing your balance.
Bring the powerhead engine to cutting
speed before entering the material to be cut.
If the blade does not turn when you squeeze the throttle trigger of the pow- erhead, make sure the attachment is fully inserted into the coupler.
Always release the throttle trigger and allow powerhead engine to return to idle speed when not cutting. The blade should not turn while the engine is run- ning at idle. If the blade turns at idle,
do not use your unit. Refer to the CAR- BURETOR ADJUSTMENT section of the
powerhead manual or contact your Sears Service Centre.
•Maintain good firm footing while us- ing the unit. Do this by planting feet firmly in a comfortable apart position.
•Cut while swinging the upper part of your body from left to right.
•As you move forward to the next area to cut, be sure to maintain your balance, and footing.
RECOMMENDED CUTTING POSITION
o'clock
Cut using the 2 | _q__t'l.,.__,,}2 |
o'ctockto 4 o'clock V't'f'_/,'
position of the f !1 _4 o'clock
blade"IV
_, WARNING: The operator or others
must not try to clear away cut material with the engine running or the blade turning to avoid serious injury. Stop en- gine and blade before removing materi- als wrapped around blade or shaft.