Sherwood RD-6513 manual Setting The Speaker Setup, When selecting the DIGITAL IN, English

Models: RD-6513

1 44
Download 44 pages 57.73 Kb
Page 33
Image 33
When selecting the DIGITAL IN

When selecting the AUTO SURROUND RD-6513(A) 2008.8.21 12:20 PM 페이지 34

ENGLISH

When selecting the DIGITAL IN

You should assign the connected DIGITAL INs to the desired of CD and VIDEO 1 ~ VIDEO 2. (For details, refer to "CONNECTING DIGITAL INs" on page 9.)

You can select the desired of OPT (optical), COX 1(coaxial 1), COX 2(coaxial 2) and ANL (analog).

Note :

In such a case that a DIGITAL IN is assigned to two input sources or more, when these input sources are selected, the digital audio signals can be heard from the same DIGITAL IN.

When selecting the AUTO SURROUND

• Depending on how to select a surround mode, you can select the auto surround mode or the manual surround mode.

OFF

: You can select the desired of different surround modes selectable for the signal being input with

(Manual surround mode)

using the MULTI CONTROL knob or the SURROUND MODE UP/DOWN (>/<) buttons.

(For details, refer to "ENJOYING SURROUND SOUND" on page 19.)

ON

: The optimum surround mode will be automatically selected depending on the signal format being

(Auto surround mode)

input.

Notes :

When the input source other than CD and VIDEO 1 ~ 2 is selected, you cannot select the auto surround mode and can select the surround mode as desired(the manual surround mode).

When the auto surround mode is selected, the surround modes other than the optimum surround mode cannot be selected.

SETTING THE SPEAKER SETUP

After you have installed this receiver and connected all the components, you should adjust the speaker settings for the optimum sound acoustics according to your environment and speaker layout.

Even when you change speakers, speaker positions, or the layout of your listening environment, you should adjust the speaker settings, too.

When performing the AUTO SETUP precedure, you need not perform the CONFIGURATION, DISTANCE and CH LEVEL setup procedures.

AUTO SET (AUTO SETUP) : To set the speaker setup and channel level setup automatically.

CONFIG (CONFIGURATION) : To select the sizes of the speakers that are connected.

DISTANCE: To enter the distance between the listening position and each speaker to set the delay time automatically for optimum surround playback.

X-OVER (CROSSOVER) : To select the desired crossover frequency.

RETURN : To return to the previous menu.

34

Page 33
Image 33
Sherwood RD-6513 manual Setting The Speaker Setup, When selecting the DIGITAL IN, When selecting the AUTO SURROUND, English