Sherwood RD-6513 manual Setting The Ch Level, English, Adjusting the current channel level

RD-6513(A) 2008.8.21 12:20 PM 페이지 39

SETTING THE CH LEVEL

ENGLISH

Note : Depending on the speaker settings ("N (None or No)"), some channels cannot be selected.

Adjusting the current channel level

•You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s memory("CAL"), not into preset memory ("REF 1", "REF 2")

•After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit your tastes. (For details, refer to "Adjusting each channel level with test tone" on page 21.)

1. Press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired channel.

Example) When selecting Dolby Digital source's LFE

2. Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to adjust the level of the selected channel or program source's LFE as desired.

• The LFE level can be adjusted within the range of -10 ~ 0 dB and other channel levels within the range of -15 ~ +15 dB

• In general, we recommend the LFE level to be adjusted to 0 dB. (However, the rcommended LFE level for some early DTS software is -10 dB.) If the recommended levels seem too high, lower setting as necessary.

3. Repeat the above steps 1 and 2 to adjust each channel level.

39