System Setup
•The setup menu is displayed on the fluorescent display and allows you to perform the setup procedures easily. In most situations, you will only need to set this once during the installation and layout of your home theater, and it rarely needs to be changed later. The setup menu consists of 5 main menus ; system, input, speaker setup, CH level and parameter. These menus are then divided up into various
■Navigating through the setup menu
•The explanations here assume you are using the buttons on the remote control when performing the setup menu operation. However, you can use the buttons on the front panel as well.
The buttons on the front panel correspond to those on the remote control as shown below.
1. Turn the setup menu on.
• The setup menu will be shown.
• To turn the menu off, press this button again.
2. Select the desired menu using the CURSOR UP(▲)/DOWN(▼) buttons.
3. Confirm your selection.
• When selecting "SYSTEM", see "SETTING THE SYSTEM" on page 31.
• When selecting "INPUT", see "SETTING THE INPUT" on page 33.
• When selecting "SPK SET", see "SETTING THE SPEAKER SETUP" on page 34.
• When selecting "CH LEVEL", see "SETTING THE CH LEVEL" on page 39.
• When selecting "PARAMTR", see "SETTING THE PARAMETER" on page 41.
• When selecting "EXIT", the setup menu will be turned off.
ENGLISH
29
