Craftsman 917.27268 manual To Start Engine, Automatic Transmission Warm UP

Page 15

ADD GASOLINE

Fill fuel tank to bottom of tank filler neck.

Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of

87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quanti- ties that can be used within 30 days to assure fuel freshness.

_CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: When operating in tempera- tures below 32°F(0°C), use fresh, clean winter grade gasoline to help insure good cold weather starting.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separa- tion and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

1.Be sure freewheel control is in the transmission engaged position.

2.Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

3.Place motion control lever in neutral

(N)position.

4.Move attachment clutch to disengaged position.

5.Move throttle control to choke position. NOTE: Before starting, read the warm and cold starting procedures below.

6.Insert key into ignition and turn key clockwise to start position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast

WARM WEATHER STARTING (50 ° F and above)

7. When engine starts, move the throttle control to the fast position.

The attachments and ground drive can now be used. If the engine does not

accept the load, restart the engine and

allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING ( 50 ° F and below)

7.When engine starts, allow engine to run with the throttle control in the

choke position until the engine runs roughly, then move throttle control to fast position. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

AUTOMATIC TRANSMISSION WARM UP

Before driving the unit in cold weather,

the transmission should be warmed up as follows:

1.Be sure the tractor is on level ground.

2.Place the motion control lever in neutral. Release the parking brake and let the clutch/brake slowly return to operating position.

3.Allow one minute for transmission to warm up. This can be done during

the engine warm up period.

• The attachments can also be used dur- ing the engine warm-up period after the transmission has been warmed up.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance. (See "TO ADJUST CARBURETOR" in the Service and Adjustments section of this manual.)

position, wait a few minutes and try

 

again. If engine still does not start,

 

move the throttle control back to the

 

choke position and retry.

15

 

Image 15
Contents IC..FTSMeWl Limited Warranty on Battery Limited Warranty on Craftsman Riding EquipmentII. Slope Operation General OperationIV. Service Do notIII. Children Across Sears Installation Service Customer ResponsibilitiesAgreements Steering To Remove Tractor from Howto SET UP Your TractorTools Required for Assembly Install SeatCheck Battery Check for Proper Position of ALL Belts Install Mulcher PlateCheck Deck Levelness DischargingH L I.,I Know Your Tractor Light SwitchHowto USE Your Tractor Towing Carts and Other ATTACH- Ments Before Starting the EngineTo Operate on Hills To TransportAutomatic Transmission Warm UP To Start EnginePurge Transmission Mowing TipsMulching Mowing Tips Before Each USE General RecommendationsTo Sharpen Blade BatteryOperator Presence System Blade CareEngine Transaxle Pump FluidLubrication Muffler Clean AIR ScreenAIR Filter Engine Cooling FinsTo Remove Mower CleaningSIDE-TO-SIDE Adjustment To Level Mower HousingBelt Removal To Adjust BrakeTo Check and Adjust Brake Belt InstallationTo Remove Wheel for Repairs Transmission Removal ReplacementAlignment Front Wheel TOE-IN/CAMBERTo Replace Fuse To Remove Hood and Grill AssemblyTo Attach Jumper Cables Interlocks and RelaysTo Adjust Throttle Control Cable Preliminary SettingTo Adjust Carburetor Acceleration Test Engine OIL BatteryTractor Fuel SystemTroubleshooting Chart ProblemCause Cause Correction CleanTrash under Problem Cause CorrectionOEo ÷IIIG OLAoK Tractor - Model Number SchematicTractor - Model Number Electrical KEY Part Description Tractor - Model Number Chassis and Enclosures Tractor - Model Number Chassis and Enclosures Tractor - Model Number Ground Drive 200 Tractor - Model Number 917.272680 Steering Assembly Tractor - Model Number 917.272680 Steering Assembly Tractor - Model Engine Tractor - Model Number Engine KEY Part Description Tractor - Model Number 917.272680 Seat AssemblyTractor - Model Number Decals X20Tractor - Model Number Lift Assembly Tractor - Model Number Lift Assembly Tractor - Model Number Mower Deck 136420 =o= 032 434 O511 7o9 947 513 544Ao3,, 3,oi 106 690577 Seat-Inlet Wrench-Spark Plug Page Suggested Guide for Sighting Slopes for Safe Operation SE/AR

917.27268 specifications

The Craftsman 917.27268 is a standout model in the realm of riding mowers, designed to offer powerful performance combined with ease of use for both residential and commercial lawn care. This versatile riding mower is equipped with a host of features that make it a valuable asset for maintaining lush and healthy lawns.

One of the most notable aspects of the Craftsman 917.27268 is its robust engine. Powered by a reliable 19 horsepower Briggs & Stratton engine, this mower provides ample power to tackle tough terrains and thick grass. The engine is paired with an automatic transmission that allows for smooth and effortless speed adjustments, ensuring that operators can easily navigate through their lawns without any hassle.

The mower's cutting deck is another standout feature. With a 42-inch cutting width, it allows for efficient mowing, reducing the number of passes needed to cover large areas. The deck also has a three-blade system, which ensures a clean and even cut every time. Additionally, the cutting height can be easily adjusted to meet the specific needs of your lawn, offering six different height settings for an optimal finish.

Ergonomic design is a key characteristic of the Craftsman 917.27268. It features a comfortable seat with a high backrest that provides ample support during extended mowing sessions. The steering wheel is positioned for enhanced control, allowing users to maneuver the mower with confidence. The mower also includes a foot-operated deck lift for straightforward height adjustments, making it user-friendly for individuals of all skill levels.

When it comes to technology, the Craftsman 917.27268 incorporates various features designed to enhance functionality. For instance, it boasts an integrated mulching capability, allowing clippings to be finely chopped and returned to the lawn as natural fertilizer. This not only saves time but also promotes healthier grass growth. Additionally, the mower is equipped with a sturdy frame and durable wheels that ensure stability and longevity, reinforcing its position as a reliable choice for lawn maintenance.

In conclusion, the Craftsman 917.27268 delivers power, versatility, and user-friendly features, making it an ideal choice for anyone looking to maintain their lawn effectively. Its combination of a capable engine, efficient cutting system, ergonomic design, and thoughtful technologies creates an appealing package for homeowners and lawn care enthusiasts alike.