Craftsman 917.27404 To Adjust Throttle Control Cable, To Replace Headught Bulb, To Replace Fuse

Keps Nut Hex BoUt

	Positive
Terminal	(Red) Cable
Guard	Negative
't'	(Black) Cable
TO REPLACE HEADUGHT	BULB

1.Raise hood.

2.Pull bulb holder out of the hole in the backside of the grill.

3.Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

4.Close hood.

mNTERLOCKS AND RELAYS

Loose or damaged wiring may cause

your tractor to run poorly, stop running, or prevent it from starting.

,, Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type

plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRmLL AS-

SEMBLY

1.Raise hood.

2.Unsnap headlight wire connector.

3.Stand in front of tractor. Grasp hood at

sides, tilt toward engine and lift off of tractor.

4.When replacing hood, be sure to reconnect the headlight wire connector.

Headlight Wire

Connector

Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the customers ex- pense, may be performed by any non-road

engine repair establishment or individual. Warranty repairs must be performed by an

authorized engine manufacturer's service outlet.

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be nec- essary. Check adjustment as described below before loosening cable. If adjust- ment is necessary, proceed as follows:

1.With engine not running, move throttle control lever from slow to choke posi- tion. Slowly move lever from choke to fast position.

2.Check that holes "A" in governor control lever and hole in governor plate

line-up. If holes "A" are not aligned, loosen clamp screw and move throttle cable until holes are aligned. Tighten clamp screw securely.

GovernorGovernor

Con_,er /Oontro, P,ate

Ho,es W' _\ % C,a_:._J3@_ ?_[ottle

_J _cX_; -- Cabre

27