• | Never | fill containers | inside | a vehicle, | on | • | Keep | nuts | and | bolts, especially | blade | ||||||||||||||
| a truck | or trailer | bed | with | a plastic | liner. |
| attachment | bolts, | tight | and | keep | equip- | ||||||||||||
| Always | place | containers | on the ground |
| ment | in good condition. |
|
|
|
|
| |||||||||||||
| away from your vehicle before filling. | • | Never | tamper | with safety devices. | Check | |||||||||||||||||||
• | Remove |
| equipment from |
| their proper | operation | regularly. |
|
| ||||||||||||||||
| the truck | or trailer and | refuel | it on the | • | Keep | machine | free of grass, | leaves, or | ||||||||||||||||
| ground. | If this is not | possible, | then |
|
| other | debris | or fuel | ||||||||||||||||
| refuel | such equipment | with | a portable |
| spillage. | Allow | machine | to cool | before | |||||||||||||||
| container, | rather than | from | a gasoline |
| storing. |
|
|
|
|
|
|
|
|
|
| |||||||||
| dispenser | nozzle. |
|
|
|
|
|
|
| • | Stop and | inspect |
| the equipment |
| if you | |||||||||
• | Keep the | nozzle | in contact | with the | rim |
| strike | an object. | Repair, if necessary, | ||||||||||||||||
| of the | fuel tank | or container | opening | at |
| before | restarting. |
|
|
|
|
|
|
| ||||||||||
| all times | until | fueling | is complete. | Do | • | Never | attempt | to make | wheel | height | ||||||||||||||
| not use a nozzle | device. |
|
| adjustments | while | the | engine | is running. | ||||||||||||||||
• | If fuel | is spilled on clothing, | change |
| • | Grass | catcher | components | are | subject | |||||||||||||||
| clothing | immediately. |
|
|
|
|
|
|
|
| to wear, | damage, |
| and | deterioration, | ||||||||||
• | Never | overfill | fuel tank. | Replace | gas |
| which could expose moving parts or | ||||||||||||||||||
| cap and | tighten | securely. |
|
|
|
|
|
| allow | objects to | be thrown. | Frequently | ||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
| check components and replace with | |||||||||||
V. GENERAL | SERVICE |
|
|
|
|
|
| manufacturer's | recommended |
| parts, | ||||||||||||||
• | Never | run a machine |
| inside | a closed |
|
| when | necessary. |
|
|
|
|
|
|
| |||||||||
|
| • Mower blades are sharp and can cut. | |||||||||||||||||||||||
| area. |
|
|
|
|
|
|
|
|
|
|
| |||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
| Wrap the blade(s) or wear gloves, and | ||||||||||||
| Never make adjustments or repairs with |
| |||||||||||||||||||||||
|
| use extra caution when servicing them. | |||||||||||||||||||||||
| the engine (motor) running. Disconnect |
| |||||||||||||||||||||||
| • Do not change the engine governor set- | ||||||||||||||||||||||||
| the spark plug wire, and keep the wire | ||||||||||||||||||||||||
|
| ting or overspeed the engine. |
|
|
| ||||||||||||||||||||
| away from the plug to prevent accidental |
|
|
|
| ||||||||||||||||||||
| • Maintain or replace safety and instruc- | ||||||||||||||||||||||||
| starting. |
|
|
|
|
|
|
|
|
|
| ||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
| tion labels, | as necessary. |
|
|
|
| ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||||||||
| &WARNING: | This lawn mower is equipped with an internal combustion engine and | |||||||||||||||||||||||
| should not be used on or near any unimproved | ||||||||||||||||||||||||
| |||||||||||||||||||||||||
| arrester meeting applicable local or state laws (if any). If a spark arrester is used, it |
should be maintained in effective working order by the operator.
In the state of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is available through your nearest Sears Parts & Repair Center (See the REPAIR PARTS section of this manual).
Serial | Number: |
|
|
|
|
| |
Date | of | Purchase: |
|
|
|
|
|
Gasoline | Capacity | / Type: | 1.0 Quarts (Unleaded | Regular) | |||
Oil Capacity: |
| 18.5 Ounces |
|
| |||
Oil Type (API | SAE | 30 (above 32°F) | or SAE | ||||
Spark | Plug (Gap: | .030") | NGK | BPR6ES |
|
| |
Valve | Clearance | (+ 0.04 mm): | Intake: 0.015 mm; Exhaust: | 0.020 mm | |||
Blade | Bolt Torque: | ft. Ibs. |
|
|
•The model and serial numbers wil! be found on a decal on the rear of the lawn mower housing. Record both serial number and date of purchase in space provided above.
4