Craftsman 917.289240 To Remove Wheel for Repairs, To Start Engine with Weak Battery

Page 25

TO REMOVE WHEEL FOR REPAIRS

1.Block up axle securely.

2.Remove axle cover, retaining ring and washers to allow wheel removal (rear wheels have a square key - Do not lose).

3.Repair tire and reassemble.

NOTE: On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

4.Replace washers and snap retaining ring securely in axle groove.

5.Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, purchase and usetire sealant from Sears. Tire sealant also prevents tire dry rot and corrosion.

Washers

Retaining

Rin(

Axle

Cover

Square

Key _

(Rear Whee_-Q_

TRANSAXLE MOTION CONTROL LEVER NEUTRAL ADJUSTMENT

The motion control lever has been preset atthe factory; adjustment should not be necessary.

1.Loosen adjustment bolt in front of the right rear wheel, and lightly tighten.

2.Start engine and move motion control lever until tractor does not move forward

or backward.

3.Hold motion control lever in that position and turn engine off.

4.While holding motion control lever in place, loosen the adjustment bolt.

5.Move motion control lever to the neutral (lock gate) position.

6.Tighten adjustment bolt securely.

Motion Control

Neutral

Lever

Lock

 

Gate

Y

Adjustment Bolt

NOTE: If additional clearance is needed to

get to adjustment bolt, move mower deck height to the lowest position.

After above adjustment is made, if the trac- tor still creeps forward or backward while motion control lever is in neutral position, follow these steps:

1.Loosen the adjustment bolt.

2.Movethe motion control lever 1/4 to 1/2 inch in the direction it is trying to creep.

3.Tighten adjustment bolt securely.

4.Start engine and test.

5.If tractor still creeps, repeat above steps until satisfied.

TO START ENGINE WITH WEAK BATTERY

A_,WARNING: Lead-acid batteries gener-

ate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the

MAINTENANCE section of this manual).

If "jumper cables" are used for emergency starting, follow this procedure:

IMPORTANT: Your tractor is equipped with a 12 volt system. The other vehicle must also be a 12 volt system. Do not use your tractor battery to start other vehicles.

TO ATTACH JUMPER CABLES -

1.Connect one endofthe RED cable to the

POSITIVE (+) terminal of each battery(A-

B), taking care not to short against tractor chassis.

2.Connect one end of the BLACK cable

to the NEGATIVE (-) terminal (C) of fully charged battery.

3.Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER-

1.BLACK cable first from chassis and then from the fully charged battery.

2.RED cable last from both batteries.

Weak or

Fully

Dead

Charged

Battery

Battery

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents SEARS, Roebuckand CO., Hoffman ESTATES, IL 60179 U.S.A LAW TractoTWO Years on RiDiNG Equipment Craftsman Full WarrantyGeneral Operation Safe Handling of Gasoline ServiceGeneral Service Repair Protection Product SpecificationsTo Adjust Seat Tools Required for AssemblyCheck Battery To Remove Tractor from CartonCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake System@@@ Know Your Tractor To SET Parking Brake HOW to USE Your TractorStopping To Adjust Gauge Wheels To Adjust Mower Cutting HeightTo Move Forward Backward To Operate MowerTransmission Engaged Transmission Disengaged To TransportReverse Operation System ROS To Start Engine Before Starting the EngineAutomatic Transmission Warm UP Check Engine OIL LevelNever engage or disengage Purge TransmissionGeneral Purpose Grease @Refer to Maintenance Engine Section Lubrication ChartGeneral Recommendations Before Each USEBrake Operation TractorTires Operator Presence System and Reverse Operation System ROSEngine Transaxle Pump FluidEngine Cooling System AIR FilterSpark Plugs MufflerDeck Washout Port CleaningTo Remove Mower To Install Mower03042tex FRONT-TO-BACK Adjustment Visual SIDE-TO-SIDE AdjustmentPrecision SIDE-TO-SIDE Adjustment To Level MowerTo Replace Mower Blade Drive Belt Belt InstallationBelt Removal To Replace Motion Drive BeltTo Start Engine with Weak Battery Transaxle Motion Control Lever Neutral AdjustmentTo Remove Wheel for Repairs To Attach Jumper CablesReplacing Battery To Remove Hood & Grill AssemblyInterlocks and Relays Engine OIL Fuel SystemCylinders Will not start Problem CauseCorrection Loss of power ProblemcauseDischarge Headlights not working If so equipped CuttingProblem Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationDOS Aiios Para EL Equipo Tractor Sears, Roebuck and Co., Hoffman Estates, ILFuncionamiento General Lesiones graves o la muerteIV. Remolque III. NiiosManipulacion Segura DE LA Gasolina Operaciones DE Servicio GeneralesPage Producto Especificaciones DELResponsabilidades DEL Cliente Servicio DE Instalacion SearsPara Remover EL Tractor DE Herramientas Necesarias Para EL MontajeLA Caja DE Carton Desempaque LA Caja DE Carton Verifique LA BateriaRevjsion DE LA Nivelacion DEL Conjunto Revision DE LA Presion DE LAS LlantasRevision DEL Sistema DE Frenos Jlista DE Revision@@@ SU Tractor Familiaricese CON SU TractorIstema DE Funcionamiento Hacia Miento Como Usar SU TractorParada LA Segadora Para Operar EN Cerros Usar EL Sistema DE Funcionamiento ATR,SPara Transportar Transmision Enganchada Transmision DesenganchadaAgreguegasolina Consejos Para Segar Purgar LA TransmisionRecomendaciones Generales Tabla DE LubricacionAntes DE Cada USO Llantas TractorVI= Rifiez Sistema Func Ionam Iento AT R/,S ROS Transeje MotorCorreas Para Cambiar EL Aceite DEL MotorLimpieza BUJiASManguera Puerto de Lavado Adaptador de Boq Para Desmontar LA Cortadora DE CespedInstale LA Segadora 03042tex Regulacion Visual DE Lado a Lado Para Nivelar LA SegadoraRegulacion DE LA Precision DE Lado Ajuste DE Delante a ATR,SRemocion DE LA Correa Paracambiarla Correa DE Impulsion DE LA Cuchilla SegadoraInstalacion DE LA Correa Montaje DE LA CorreaPara ADJ Untar LOS CAB LES D E EM Palm E MEC.&NICOPara Cambiar EL Fusible Reemplazar LA BateriaPara Remover EL Conjunto DEL Capo Y DEL Enrejado Para Cambiar LA Bombilla DE LA LUZ DelanteraSistema DE Combustible OtrosAceite DEL Motor CilindrosIDENTIFICACI6N DE Problemas Problema Causa CorreccionEstrangulacion Choke Problemacausa Identificacion DE ProblemasCorreccion Las cuchillas Page 15GRADOS MAX Operacion SeguraYour Home Needmore
Top Page Image Contents