MUFFLER
Inspect and replace corroded muffler as it could create a fire hazard and/or damage.
SPARK PLUG
Replace spark plug at the beginning of each mowing season or after every 100 hours of operation, whichever occurs first. Spark plug type and gap setting are shown in the "PRODUCT SPECIFIC- ATIONS" section of this manual.
CLEANING
IMPORTANT: For best performance, keep mower housing free of
_I:_CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
•Clean the underside of your lawn mower by scraping to remove
•Clean engine often to keep trash from
accumulating. A clogged engine runs hotter and shortens engine life.
•Keep finished surfaces and wheels free of all gasoline, oil, etc.
•We do not recommend using a garden hose to clean lawn mower unless the
electrical system, muffler, air filter and carburetor are covered to keep water out. Water in engine can result in short- ened engine life.
CLEAN UNDER DRIVE COVER
Clean under drive cover at least twice a season. Scrape underside of cover with putty knife or similar tool to remove any
WATER WASHOUT FEATURE
Your lawn mower is equipped with a fitting that allows quick and easy cleaning of the underside of the housing. To use this feature, proceed as follows:
1.Move lawn mower to an area of cut
grass or another hard surface.
NOTE: Water, grass and other debris will drain from beneath the mower housing during the washout process.
2.Remove grass catcher and discharge chute assembly from lawn mower.
3.Close mulcher door (if equipped).
4.Connect a garden hose to the fitting where shown.
IMPORTANT: Be sure the garden hose is not routed under the lawn mower housing or entangled in the wheels.
5.Turn on water supply and check for leaks at the fitting.
If no leaks are present, start engine (as described in the Operation section of this
manual) and let engine run until the under- side of the lawn mower is clean.
,_ WARNING: Do not engage the drive system during the washout process.
6.Shut off the engine.
7.Shut off water supply and remove hose
from fitting.
CAUTION: Do not remove hose from fitting while engine is running. Water in engine can result in shortened engine life. 8, Start engine (as described in the Op-
eration section of this manual) and let engine run for a full minute to remove excess water from mower.
Hose
15