Craftsman 917.289030 Towing Carts and Other Attach, Ments, ADD Gasoline, To Start Engine

Page 15

TOWING CARTS AND OTHER ATTACH-

MENTS

Tow only the attachments that are recom- mended by and comply with specifications of the manufacturer of your tractor. Use common sense when towing° Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING 'THE ENGINE CHECK ENGINE OIL LEVEL

The engine inyour tractor has been shipped, from the factory, already filled with summer weight oil.

1.. Check engine oil with tractor on level ground.

2, Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until

"FULE' mark on dipstick is reached. Do not overt_ill,

For cold weather operation you should change oil for easier starting (See the oil viscosity chart in the Maintenance section of this manual).

To change engine oil, see the Mainte- nance section in this manual.

ADD GASOLINE

Fill fuel tank to bottom of filler neck. Do

not overfill, Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life) oDo not mix oil with gasoline_ Purchasefuel in quantitiesthat can be used within 30 days to assure fuel freshness.

_CAUTION:

Wipe

off

any

spilled oil or

fuel. Do

not store, spill or

use gasoline near

an open

flame.

 

 

 

 

IMPORTANT:

When

operating

in temper-

atures below 32°F(00C), use fresh, clean winter grade gasoline to help insure good cold weather starting.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer, Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information, Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine

1.Sit on seat in operating position, depress

clutch/brake pedal and set parking brake°

2o Place gear shift lever in neutral (N) posi- tion.

3.Move attachment clutch to disengaged position.

4.Move throttle control to choke position. NOTE: Before starting, read the warm and cold starting procedures below.

5.Insert key into ignition and turn key clockwise to start position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute, if the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke position and retry.

WARM WEATHER STARTING (50 ° F and above)

6o When engine starts, move the throttle control to the fast position.

-The attachments and ground drive can now be used, If the engine does not accept the load, restart the engine and

allow it to warm up for one minute using the choke as described above.

15

Image 15
Contents Sears Craftsman Help Line Lawn TractoDays on Battery Craftsman Limited Warranty TWO Years on TractorGeneral Operation Service Safe Handling of Gasoline Slope OperationIII. Children General Service Specifications 1tlt11111t Adapter Install Seat Tools Required for AssemblyAssemble Extension Shaft and Boot Install Steering WheelCheck Battery To Roll Tractor OFF SkidLabel Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL Belts@@@ Reverse Operation System ROS Know Your TractorGround Drive HOW to USE Your Tractor to SET Parking BrakeTo Adjust Mower Cutting Height Stopping Mower BladesMower ADD Gasoline Towing Carts and Other AttachMents Before Starting the Engine Check Engine OIL LevelMowing Tips Maintenance BeforeSchedule Blade Removal Blade CareBelts BatteryTo Clean Battery and Terminals Transaxle CoolingAIR Filter CleaningClean AIR Screen IN-LINEFUEL FilterService or Adjustments To Install MowerTractor To Remove Mower To Level Mower Housing SID E-TO-S IDE AdjustmentFRONT-TO-BACK Adjustm ENT To Check Brake Belt InstallationTo Replace Mower Blade Drive Belt Belt RemovalFront Wheel TOE-IN!CAMBER To Adjust Throttle Control Cable To Remove Hood and Grill ASSembly Acceleration Test To Adjust CarburetorPreliminary Setting Final SettingCylinders TractorFuel System Engine OILProblem Cause CorrectionEngine will not turn over Problem Will Poor Cut unevenCutting MowerCausecorrection Engine dies when tractor is shifted into reverseOnly Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationGARANTiA Limitada DE Craftsman Page IV. Remolque DE LA GasolinaGenerales Page DEL Hoja de pendiente Llaves Adjunte EL Volante Herramientas Necesarias Para EL MontajeAntes DE Remover EL Tractor DE LA CorrederaPara Hacer Rodar EL Tractor Verifique LA BateriaRevision DE LA Presion DE LAS Llantas DA DE Todas LAS CorreasLista DE Revision @@@ Pedal DEL EMBRAGUE/FRENO Se usa Macho DE LA Palanca DE LevantaCIA Atras Como Usar SU TractorMiento Para Moverse Hacia Adelante Y HAPara Transpo Rtar Para Parar LAS Cuchillas DE LA SegaUsar EL Sistema DE Funcionamiento Para Operar EN CerrosMotor Consejos Para Segar Arranque CON Tiempo FRO 50 Y MenosGenerales Tabla DE Lubricacion Antes DE CadaImportante Llantas Virifiiz S1STEMA Presencia OperadorCuidado DE LA Cuchilla LUBRICACI6N NalesEnfriamiento DEL Transeje CorreasBujias Para Instalar LA Segadora Tractor Para Remover LA SegadoraAjuste Desde Adelante Hacia ATR,S Para Nivelar LA Caja DE LA SegaDora Ajuste DE Lado a LadoDE Impulsion SegadoraIMPULSI6N DE Movimiento Para Cambiar LA Bombilla DE LA LUZ Delantera Para Adjuntar LOS Cables DE EmpalmePara Remover LOS CABLES, Invierta EL Orden Reemplazar LA BateriaPrueba DE LA Aceleracion Para Ajustar EL Cable DE Control DE LA ACELERACI6NAjuste Preliminar Ajuste FinalOtros Aceite DEL MotorIdentificacion DE Problemas SearsEl motor suena pero noarranca Problema Vibraci6n excesiva El tractor se port en marcha atr&sMa corte-disparejo Problema Las cuchillasMala descarga del csped Page Page OPERAClON Segura Ea/rs

28903, 917.289031, 917.28903, 917.289030 specifications

The Craftsman 917.289031, 917.289030, 28903, and 917.28903 represent a range of robust lawn mowers designed to deliver exceptional performance for residential lawns. Renowned for their reliability, these models combine user-friendly features with advanced technology, making them ideal for both novice and experienced lawn care enthusiasts.

One of the standout features of these Craftsman mowers is their powerful engines, which typically range between 20 to 24 horsepower. This power enables them to handle various types of grass and terrains, providing an efficient cutting experience. The mowers are equipped with a durable, steel cutting deck that ensures a clean and even cut, contributing to a professionally manicured lawn.

Another key characteristic of the Craftsman 917 series is the presence of the innovative Auto Drive system. This technology allows users to engage the mower without having to constantly push, making it easier to navigate through yards, especially for those with larger lawns. The adjustable speed settings further enhance maneuverability, enabling operators to tailor the pace of the mower to their comfort level and the lawn's requirements.

The cutting height on these models is also adjustable, giving users the flexibility to customize their mowing experience. With heights ranging from 1.5 inches to 4 inches, these mowers cater to different grass types and seasonal conditions, ensuring optimal grass health and appearance.

Safety is paramount in the design of these Craftsman mowers. They come equipped with features such as blade brakes and safety switches that halt blade rotation when the operator leaves the seat. This attention to safety minimizes the risk of accidents during operation.

Maintenance is made simpler with the inclusion of easily accessible components and a user-friendly design. Craftsman has integrated features that allow for quick access to the air filter, spark plug, and oil fill, promoting regular upkeep without the need for specialized tools.

In summary, the Craftsman 917.289031, 917.289030, 28903, and 917.28903 models stand out in the lawn mower market thanks to their powerful engines, advanced Auto Drive technology, adjustable cutting heights, and enhanced safety features. Whether one is tackling a small patch of grass or a sprawling lawn, these mowers provide the versatility and durability needed to achieve impressive results year after year.