Craftsman 917.273631 manual Fuel System, Engne OIL

Page 27

Immediately prepare your tractor for stor- age at the end of the season or if the trac- tor will not be used for 30 days or more.

_I, CAUTmON: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire tractor (See "CLEANING" in the Maintenance section of this manual).

2.Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Maintenance section of this manual.

4.Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

Fully charge the battery for storage. After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be disconnected and battery cleaned thoroughly (see "TO

CLEAN BATTERY AND TERMINALS" in the Maintenance section of this manual). After cleaning, leave cables discon- nected and place cables where they cannot come in contact with battery terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

FUEL SYSTEM

mMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel hose, or tank during storage. Also, alcohol

blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can dam- age the fuel system of an engine while in storage.

Empty the fuel tank by starting the en- gine and letting it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or stor- age container. Always follow the mix ratio found on stabilizer container. Run engine

at least 10 minutes after adding stabilizer to allow the stabilizer to reach the car-

buretor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENG(NE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See "ENGINE" in the Maintenance section of this manual).

1.Remove spark plug(s).

2.Pour one ounce of oil through spark plug hole(s) into cylinder(s).

3.Turn ignition key to "START" position for a few seconds to distribute oil.

4.Replace with new spark plug(s).

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors

and cover it to give protection from dust and dirt.

Cover your tractor with a suitable pro- tective cover that does not retain mois-

ture. Do not use plastic. Plastic cannot

breathe which allows condensation to

form and will cause your tractor to rust.

mMPORTANT: Never cover tractor while engine and exhaust areas are still warm.

27

Image 27
Contents Craftsmiin Sears, Roebuck and Co.,Dept.817WA, Hoffman Estates, IL Limitedwarrantyon CraftsmanridingequipmentSlope Operation Do not Taft grass can hide obstaclesPage U1R IAPFSG-SLRC12YC PSIOil Drain Tube For Future Use HOW to SET UP Your Tractor Check Battery Adjust SeatTo Remove Tractor from Carton Unpack Carton Reposition RmGHT Rear Gauge Check for Proper POSmTmON ALL BeltsCheck Brake System @@@@ Know Your Tractor STOPPmNG To Operate on Hills To Adjust Gauge WheelsTo Transport To Operate MowerBefore Starting the Engine Check Engine OIL Level ADD GasolineTo Start Engine 00272 Before Each USE ErvcdatesBlade Removal TractorOperator Presence System Blade CareTo Change Engine OIL To Clean Battery and TerminalsTransaxle Cooling Batt E RYSpark Plugs IiufflerTractor To Remove Mower Alternate SIDE-TO-SIDE Adjustment Method SIDE-TO-SIDE Adjustment with Bubble LevelBoth Front Links Must be Equalin Length Belt InstallationTo Check and Adjust Brake To Adjust BrakeTo Remove Wheel for Repairs Transaxle Gear Shift Lever NEU- Tral AdjustmentMent Front Wheel TOE=IN/CAMBERTo Remove Hood and Grill AS- Sembly Acceleration Test To Adjust CarburetorPreliminary Setting Final SettingEngne OIL Fuel SystemCause Operator Leaves Seat With attach Ment Clutch Engaged CORRECTmONEngine Continues To run whenRemove Obstruction Not rotate Problem CauseBattery wiii not charge CORRECTmON Mower blades wiiiBlack Tractor o o Model Number SCHEMATmCTractor - Model Number J21Electrical ELECTRmCAL Tractor o o Model NumberTractor o o Model Number 917.273631 CHASSmS and Enclosures KEY Part Tractor ooMODEL Number 917.273631 CHASSmSAND EnclosuresTractor - Model Number Ground Drive Ground DRmVE Tractor Model NumberSTEERmNG KEY Part Optional Equipment DESCRiPTiON KEY Tractor Model Number Seat AssemblyPart Description DecalsUFT Assembly KEY Part Description Tractor - Model Number UFT AssemblyMower Deck KEY Part NO. NO.DESCRIPTION Tractor Model Number DANATRANSA×LE==MODELNUMBER4360 EMD Dana TRANSAXLE==MODEL Number 4360 EMD LOO8 144I 947 Intake 267 695134 Screw Casing Clamp 691279 Tractor ooMODEL Number Page Suggested Guide for Sighting Slopes for Safe Operation Rev 7.6.04 TRiMH IiiiiiiiiiiiiiiiiiiiCanada Iiiiiiiiiiiiiiiiiii