Craftsman 917.27207 owner manual Cleaning, Tractor To Remove Mower, To Install Mower

Page 21

C'am0/ C,om

FuelPi,ter

CLEANING

•Clean engine, battery, seat, finish, etc. of all foreign matter.

•Keep finished surfaces and wheels free of all gasoline, oil, etc.

•Protect painted surfaces with automo- tive type wax.

We do not recommend using a garden hose to crean your tractor unless the electrical system, muffler, air filter and carburetor are covered to keep water out. Water in engine can result in a short- ened engine life.

,_ CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:

1.Depress clutch/brake pedal fully and set parking brake,

2.Place gearshift lever in neutral (N) position.

3.Place attachment clutch in "DISENGAGED" position.

4.Turn ignition key "OFF" and remove key.

5.Make sure the blades and all moving parts have completely stopped.

6.Disconnect spark plug wire from spark plug and place wire where it cannot

come in contact with plug.

TRACTOR

TO REMOVE MOWER

Mower will be easier to remove from the right side of tractor.

1.Place attachment clutch in "DISEN- GAGED" position.

2.Move attachment lift lever forward to lower mower to its lowest position.

3.Roll bert off engine pulley.

4.Remove small retainer spring, and lift

9.Raise lift lever to raise suspension arms. Slide mower out from under

tractor.

IMPORTANT: If an attachment other than the mower deck is to be mounted on the tractor, remove the front links and hook

the clutch spring Into square hole in frame,

TO INSTALL MOWER

clutch spring off pulley bolt.

5.Remove large retainer spring, slide collar off and push housing guide out of bracket.

6.Disconnect anti-swaybar from chassis bracket by removing retainer spring.

7.Disconnect suspension arms from rear deck brackets by removing retainer springs.

8.Disconnect front links from deck by removing retainer springs.

1.Raise attachment lift lever to its highest position.

2.Slide mower under tractor with discharge guard to right side of tractor.

3.Lower lift lever to its lowest position.

4.Install mower in reverse order of removal instructions.

.

,._

.2 . ,t

Small Retainer Spring

-_'':-""_":"-_-Square Hole

Suspension Arms

,-

Clutch Spring_,

ine Pulley

Retainer

Anti-Sway

Springs

Housing Guide

Largg

(Both Sides)

\\

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents ICRRFTSMRN+I Limited 90 DAY Warranty on Battery General Operation II. Slope OperationDo not III. Children IV. ServiceSafety is Involved 3APACITY Repair AgreementCustomer Responsibilities Steering WheelInsert Howto SET Upyourtractor Check Battery Tools Required For AssemblyBefore Removingtractor from Skid Attach Steering Wheel To Removetractor from CartonInstall Seat Checklist Install Mulcher PlateRlR N H L Knowyourtractor Attachment Clutch Lever UsedParking Brake Lever Locks Howto Useyourtractor To SET Parking Brake To Adjust Mower Cutting HeightTo USE Throttle Control To Move Forward and BackwardTo Operate Mower To Adjust Gauge WheelsTo Operate On Rills To TransportBefore Startingthe Engine Check Engine OIL Level Towing Carts and Other AttachmentsADD Gasoline To Start EngineMOWlNGTIPS Mower should be properly leveled for Level Mower HousingLubrication Chart Maintenance ScheduleGeneral Recommendations Before Each USETires Brake OperationOperator Presence System Blade CareClean AIR Intakfjcooling Areas Clean AIR ScreenBelts Transaxle CoolingSpark Plugs AIR FilterEngine OIL Filter MufflerCleaning To Install MowerTractor To Remove Mower Underinflated, you will not properly adjust your mower To Level Mower HousingSIDE-TO-SIDE Adjustment Raise mower to its highest positionTo Adjust Brake Belt InstallationTo Replace Mower Blade Drive Belt Belt RemovalBattery Transaxle Gear Shift Lever Neutral AdjustmentTo Adjust Steering Wheel Alignment To Start Engine with a WeakTo Remove Hood and Grill Assembly Replacing BatteryTo Replace Headlight Bulb Interlocks and RelaysCable EngineSeats in carburetor may result if turned in too tight SrPecedetCEngine Fuel System TractorEngineoil CylindersProblem Troubleshooting ChartCause Correction EngineExcessive ProblemcauseVibration Poor cut unevenWhen turning Battery Will NotMower blades will Not rotateTractor - Model Number SchematicElectrical 27 73510400 Nut Keps Hex 1/4-20 Uric 22 4152JBulb Light #1156Tractor - Model Number Chassis and Enclosures 169830 Tractor -- Model Number Chassis and Enclosures16 x 3/4 18 126938X BumperHood11G TRACTOR- Model Number Ground Drive150 166Engine Transaxle146682 Return BrakeTractor - Model Number Steering Assembly 139768 Tractor - Model Number 917.272070 Steering Assembly154427 Fitting, Grease170548 Control, Throttle 17720410 Spark ArresterBrn/Dbr Guard 158990Blk 72050412 Tractor - Model Number Seat Assembly1700O16 13/32Wheels & Tires Decals1718 Tractor - Model Number Lift Assembly173288 Link Front 163552Tractor --MODEL Number Mower Deck TRACTOR--MODEL Number Mower Deck 41A PEERLESSTRANSAXLE- Model Number 206-545C Cylinder HEAD, Valve and Breatheri Rod, push IGNITION/ELECTRICAL Blower Housing and Bafflesi 12-113-53-S Decal Air Cleaner Inches 1 inch = 25.4 mm 12-041-02-S Gasket Air Cleaner12-096o24-S 12-083-f2-SKk t,J Starting System Crankshaftj Exhaust Kit, fuel Page Page Page Only Ride UP and Down Hill Not Across Hill Suggested Guide for Sighting Slopes for Safe OperationGet it fixed, at your home or ours

917.27207 specifications

The Craftsman 917.27207 is a versatile and robust lawn mower that combines power, efficiency, and user-friendly features, making it an excellent choice for homeowners looking to maintain their lawns effortlessly. This walk-behind mower is designed to tackle various grass types and terrains, ensuring a clean, even cut every time.

One of the standout features of the Craftsman 917.27207 is its powerful engine. Equipped with a dependable 159cc engine, it provides ample power to handle even the thickest grass. The manual start ensures reliability, allowing users to get their mowing tasks done quickly without worrying about battery issues. The engine is designed for fuel efficiency, helping homeowners save on gas while minimizing their environmental footprint.

In addition to its powerful engine, the Craftsman 917.27207 features a 21-inch cutting deck. This mid-sized deck strikes a perfect balance between maneuverability and cutting capacity, making it ideal for small to medium-sized lawns. The steel construction adds durability, promising longevity and resilience against wear and tear.

Another key characteristic of the Craftsman 917.27207 is its adjustable cutting heights. With six different height settings, ranging from 1.25 inches to 3.75 inches, users can customize their mowing experience to achieve their desired grass length. This feature is particularly beneficial during different seasons when grass growth varies.

The mower also includes a rear bagger option, making grass collection efficient and hassle-free. The 2-in-1 functionality allows users to choose between mulching and bagging, providing flexibility based on their lawn care preferences. The mulching feature finely chops grass clippings, allowing them to return to the lawn as natural fertilizer, promoting healthier growth.

In terms of ergonomics, the Craftsman 917.27207 is designed with user comfort in mind. The adjustable handle provides customizable height options, ensuring that users can mow comfortably without straining their backs. Lightweight yet sturdy, the mower is easy to maneuver around obstacles and tight corners.

Ultimately, the Craftsman 917.27207 brings together power, performance, and adaptability, making it a solid choice for any DIY lawn care enthusiast. With its impressive features and reliable engineering, keeping lawns looking their best has never been easier.
Top Page Image Contents