Craftsman 917.27207 owner manual Tractor, Engine Fuel System, Engineoil, Cylinders, Other

Page 27

Immediately prepare your tractor for storage at the end of the season or if the

tractor will not be used for 30 days or more.

,_ CAUTON: Never store the tractor

with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc, Store in a clean, dry area.

1.Clean entire tractor (See "CLEANING" in the Maintenance section of this

manual).

2.Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Mainte- nance section of this manual.

4.Be sure that all nuts, bolts and screws are securely fastened, inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting,

BAFrF_RY

Fully charge the battery for storage,

After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be disconnected

and battery cleaned thoroughly (see

"TO CLEAN BATTERY AND TERMI- NALS" in the Maintenance section of

this manual).

After cleaning, leave cables discon- nected and place cables where they cannot come in contact with battery terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: It is important to prevent gum deposites from forming in essential fuel system parts such as carburetor, fuel

hose, or tank during storage. Also, experiance indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of and engine while in storage.

1.Drain the fuel tank.

2.Start the engine and let it run until the

fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run

engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach

the carburetor. Do not drain the gas tank and carburetor if using fuel stabilizer.

ENGINEOIL

Drain oil (with engine warm) and replace with clean engine oil. (See "ENGINE" in the Maintenance section of this manual).

CYLINDER(S)

1.Remove spark plug(s).

2.Pour one ounce of oil through spark plug hole(s) into cylinder(s).

3.Turn ignition key to "START" position for a few seconds to distribute oil.

4.Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors and cover it to give protection from dust and dirt.

Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows conden-

sation to form and will cause your tractor to rust.

IMPORTANT: Never cover tractor while engine and exhaust areas are still warm.

27

Image 27
Contents ICRRFTSMRN+I Limited 90 DAY Warranty on Battery General Operation II. Slope OperationDo not III. Children IV. ServiceSafety is Involved 3APACITY Repair AgreementCustomer Responsibilities Steering WheelInsert To Removetractor from Carton Tools Required For AssemblyHowto SET Upyourtractor Check Battery Before Removingtractor from Skid Attach Steering WheelInstall Seat Checklist Install Mulcher PlateRlR N H L Knowyourtractor Attachment Clutch Lever UsedParking Brake Lever Locks To Move Forward and Backward To Adjust Mower Cutting HeightHowto Useyourtractor To SET Parking Brake To USE Throttle ControlTo Transport To Adjust Gauge WheelsTo Operate Mower To Operate On RillsTo Start Engine Towing Carts and Other AttachmentsBefore Startingthe Engine Check Engine OIL Level ADD GasolineMOWlNGTIPS Mower should be properly leveled for Level Mower HousingBefore Each USE Maintenance ScheduleLubrication Chart General RecommendationsBlade Care Brake OperationTires Operator Presence SystemTransaxle Cooling Clean AIR ScreenClean AIR Intakfjcooling Areas BeltsMuffler AIR FilterSpark Plugs Engine OIL FilterCleaning To Install MowerTractor To Remove Mower Raise mower to its highest position To Level Mower HousingUnderinflated, you will not properly adjust your mower SIDE-TO-SIDE AdjustmentBelt Removal Belt InstallationTo Adjust Brake To Replace Mower Blade Drive BeltTo Start Engine with a Weak Transaxle Gear Shift Lever Neutral AdjustmentBattery To Adjust Steering Wheel AlignmentInterlocks and Relays Replacing BatteryTo Remove Hood and Grill Assembly To Replace Headlight BulbSrPecedetC EngineCable Seats in carburetor may result if turned in too tightCylinders TractorEngine Fuel System EngineoilEngine Troubleshooting ChartProblem Cause CorrectionPoor cut uneven ProblemcauseExcessive VibrationNot rotate Battery Will NotWhen turning Mower blades willTractor - Model Number SchematicElectrical 27 73510400 Nut Keps Hex 1/4-20 Uric 22 4152JBulb Light #1156Tractor - Model Number Chassis and Enclosures 18 126938X BumperHood Tractor -- Model Number Chassis and Enclosures169830 16 x 3/4166 TRACTOR- Model Number Ground Drive11G 150Return Brake TransaxleEngine 146682Tractor - Model Number Steering Assembly Fitting, Grease Tractor - Model Number 917.272070 Steering Assembly139768 154427158990 Spark Arrester170548 Control, Throttle 17720410 Brn/Dbr Guard13/32 Tractor - Model Number Seat AssemblyBlk 72050412 1700O16Wheels & Tires Decals163552 Tractor - Model Number Lift Assembly1718 173288 Link FrontTractor --MODEL Number Mower Deck TRACTOR--MODEL Number Mower Deck 41A PEERLESSTRANSAXLE- Model Number 206-545C Cylinder HEAD, Valve and Breatheri Rod, push IGNITION/ELECTRICAL Blower Housing and Bafflesi 12-083-f2-S 12-041-02-S Gasket Air Cleaner12-113-53-S Decal Air Cleaner Inches 1 inch = 25.4 mm 12-096o24-SKk t,J Starting System Crankshaftj Exhaust Kit, fuel Page Page Page Only Ride UP and Down Hill Not Across Hill Suggested Guide for Sighting Slopes for Safe OperationGet it fixed, at your home or ours

917.27207 specifications

The Craftsman 917.27207 is a versatile and robust lawn mower that combines power, efficiency, and user-friendly features, making it an excellent choice for homeowners looking to maintain their lawns effortlessly. This walk-behind mower is designed to tackle various grass types and terrains, ensuring a clean, even cut every time.

One of the standout features of the Craftsman 917.27207 is its powerful engine. Equipped with a dependable 159cc engine, it provides ample power to handle even the thickest grass. The manual start ensures reliability, allowing users to get their mowing tasks done quickly without worrying about battery issues. The engine is designed for fuel efficiency, helping homeowners save on gas while minimizing their environmental footprint.

In addition to its powerful engine, the Craftsman 917.27207 features a 21-inch cutting deck. This mid-sized deck strikes a perfect balance between maneuverability and cutting capacity, making it ideal for small to medium-sized lawns. The steel construction adds durability, promising longevity and resilience against wear and tear.

Another key characteristic of the Craftsman 917.27207 is its adjustable cutting heights. With six different height settings, ranging from 1.25 inches to 3.75 inches, users can customize their mowing experience to achieve their desired grass length. This feature is particularly beneficial during different seasons when grass growth varies.

The mower also includes a rear bagger option, making grass collection efficient and hassle-free. The 2-in-1 functionality allows users to choose between mulching and bagging, providing flexibility based on their lawn care preferences. The mulching feature finely chops grass clippings, allowing them to return to the lawn as natural fertilizer, promoting healthier growth.

In terms of ergonomics, the Craftsman 917.27207 is designed with user comfort in mind. The adjustable handle provides customizable height options, ensuring that users can mow comfortably without straining their backs. Lightweight yet sturdy, the mower is easy to maneuver around obstacles and tight corners.

Ultimately, the Craftsman 917.27207 brings together power, performance, and adaptability, making it a solid choice for any DIY lawn care enthusiast. With its impressive features and reliable engineering, keeping lawns looking their best has never been easier.