STEP 23: (SEE FIGURE 24)
Assemble grip (OO) to grip assembly.
Assemble grip assembly to handle assembly using a 5/16" x
(LL)and then slide it back inside the curled edge of the fitting.
Assemble cable end fitting (LL) over 1/4" weld bolt on grip assembly and secure with one 1/4" nylock nut (R) and then back nut off 1/2 turn.
NOTE: Do not over tighten 1/4" nylock nut, cable end fitting must pivot freely.
1/4" WELD | DOLT |
GRmP ASSEMBLY | CABLE END |
| FreTTING (LL) |
GRmP (OO) | 1/4" NYLOCK |
k_ | NUT (R) |
HANDLE | 5/16" | NYLOCK |
ASSEMBLY | NUT (V) | |
| 5/16" X 1ol/2" | CABLE |
| HEX BOLT (M) |
|
FIGURE 24
STEP 24: (SEE FIGURE 25)
,Assemble the upper lift handle onto the lower lift handle and fasten using a 1/4" x
1/4" x 1ol/2"
BOLT (N)
NUT (D)
FIGURE 25
STEP 25: (SEE FIGURE 26)
oAttach the lower lift handle to the right side of the frame assembly using two 5/16" x 1o3/4" hex bolts (D) and 5/16" nylock nuts (V),
LmFT HANDLE
5116" | NYLOCK |
| |
NUT | (V) | 5/16" | X |
|
| HEX | DOLT (D) |
LIFT BRACKET
FIGURE 26
STEP 26: (SEE FIGURE 27)
Insta!l the trigger assembly to the lift handle using an oval screw (AA).
Connect the hooked end of the cable wire into the index lift rod. Insta!l the threaded end of the cable into
the notch in the top of the lift bracket, ptacing one jam nut on each side of the notch with the lock washer below the notch.
Adjust the jam nuts so that when the trigger on the lift handle is squeezed, the bottom of the index lift rod raises enough to release from the latched position. The index lift rod should also lower far enough to lock in the latched position when the trigger is released. Secure cable to handle with a plastic tie (HH) to prevent cable from interfering with tractor. Cut off extra plastic on end of tie.
OVAL ii...._% | ] |
SCR "_/ | LUFTRELEASE |
| CABLE |
TRIGGED.E×NOT
I -.b,WADHEB
lUNDEX
([4 I
......ROD
FIGURE 27
12