HEX Bolt C Spacer Y Nylock | Craftsman 486.24414 specification

STEP 4: (SEE FIGURE 4)

,Place a 1/2" washer (EE) and then a short spacer (Y) onto a 1/2" x 1-1/2" hex bolt (C). Instal! the bolt in the bottom hole at the front of the R. H. side plate and secure it with a 1/2" nylock nut (P). Repeat for the L.H. side plate,

Skip to step 8 on page 8.

STEP 6: (SEE FIGURE 6)

,Fasten the R.H. side plate (bend facing out) to the two holes indicated in the tractor frame. Use two 3/8" x 1" hex bolts (F) and 3/8" lock washers (Z). If the bolts insert loosely into the tractor frame, use two 3/8" nylock nuts (Q) on the inside of the frame. Repeat for the LH. side.

3/8" NYLOCK NUT (Q) (IF NEEDED)

1/2" X 1ol/2"

HEX BOLT (C)

SPACER (Y)

	\
3/8" x 1"	\	\
	h
HEX BOLT (F)		"\	_j

1/2" WASHER (EE)

FIGURE 4

1/2" NYLOCK

NUT (P)

FIGURE 6

STEP 7: (SEE FIGURE 7)

iNSTRUCTiONS FOR TRACTORS WITH DUAL FRONT DECK SUSPENSION BRACKETS

STEP 5: (SEE FIGURE 5)

,Remove bolts from holes shown in illustration if they are present.

REMOVE BOLTS

FROM THESE HOLES

FRONT

SUSPENSmON

BRACKET

,Place a 1/2" washer (EE) and then a short spacer (Y) onto a 1/2" x 1-1/2" hex bolt (C). Install the bolt in the bottom hole at the front of the R.H. side plate and secure it with a 1/2" nylock nut (P). Repeat for the LH. side plate.

Go to step 8 on page 8.

HEX BOLT (C)	SPACER (Y)
		1/2" NYLOCK
1/2" WASHER (EE)		NUT (P)

FIGURE 7

FIGURE 5