MOUNTING BLADE TO TRACTOR
STEP 1 : (SEE FIGURE 28}
,Attach the frame assembly to the frame brackets by sliding the notches in the frame assembly onto the shouJder boJts on the frame brackets.
L9
ATTACH FRA[tvIE ASSEMBLY
TO SHOULDER BOLTS
FIGURE 28
STEP 2: (SEE FIGURE 29)
,Stand on the right side of the blade. Squeeze the trigger on the lift handle and Jiftthe handle. Release the trigger, but do not al!ow handle to lower into locked position.
,Stand on the left side of the blade. Grip the round bar at the top of the frame assembly and lift up to align the hoJes in the frame assembly with the holes in the frame brackets.
,From the left side, insert the attachment rod through the holes in the frame assembly and the frame brackets and secure with a haircotter pin (KK).
NOTE: Blade hidden in illustration for better view.
ROUND BAR
HAIROOTTER
PIN (KK)
LiFT
STEP 3: (SEE FIGURE 30)
,Attach the small holes of the Jift Jinks to the weJded pins on the frame bracket and secure with haircotter pins (KK), The lift link should angle to the inside,
HA{RCOTTER
PmN(KK)
LUFTLiNK
FIGURE 30
STEP 4: (SEE FIGURE 31)
,Attach the lift Jinks to the frame assembly:
A. Insert a clevis pin (ll) through the frame assembly from the outside.
B.Place two 5/8" washers (DD) onto the clevis pin.
C.PJace the end of the lift tink onto the cJevis pin.
D.Place a 5/8" washer (DD) onto the clevis pin and secure with a haircotter pin (KK).
LiFT LmNK
CLEVUS
HAIRCOTTER
FIGURE 29
PiN (m0 FRAME ASSEMBLY
FIGURE 31
13