STEP 11: (SEE FIGURE 12)
oAssemble a 3/8" x 1ol/4" carriage bolt (E) through the cable mount bracket (GG) and then mount it from the left side to the square holes in the angle lock bars, Secure the bracket at the angle shown in figure 14 with a 3/8" nylock nut (Q).
3/8" NYLOCK NUT (Q)
_ | _ I / | /, BRACKET (GG) | |
| O |
|
|
FIGURE 12
STEP 12: (SEE FIGURE 13)
Select the control cable with two threaded ends, Select the threaded end that has no rubber cap or nuts and assemble a 5/16" hex jam nut (T) approximately 3/4" onto the threads, Insert the threaded end of the cable through the round hole in the cable mount bracket (GG) and secure it with another 5/16" hex jam nut (T). Tighten the second nut while keeping the first nut in place.
Assemble the ball end of the cable wire up through the hole in a cable end fitting (LL) and then slide it back inside the curled edge of the fitting.
BALL END
] | 5/16" BEX |
| (T) |
FIGURE | 13 |
STEP 13: (SEE FIGURE 14)
Attach the cable end fitting (LL) and the long spacer
(U)to the left hand hole in the channel and lift bracket using a 1/4" x 1ol/2" hex bolt (N) and 1/4" nylock nut (R)=Tighten, keeping the cable end fitting aligned with the threaded end of the cable.
CABLE MOUNT BRACKET | 1/4" X | |
| HEX BOLT (N) | |
| CABLE | END |
| FiTTiNG | (ll) |
LONG SPACER(U)
CHANNEL
cKET
1/4" NYLOCK NUT (R)
FIGURE 14
STEP 14: (SEE FIGURE 15)
Attach the lift bracket to the right hand hole in the channel, next to the long spacer, Use a 5/16" x 3/4" hex bolt (G) and 5/16" nylock nut (V).
Attach the frame assembly to the channel assembly. Fit one side of the frame assembly onto the 3/4" rod of the channel and then fit the other side onto the rod. Secure each side with a 3/4" washer (BB) and a 1/8" x 1ol/4" cotter pin (O).
ASSEMBLY
FRAME
5/16" X 3/4" BOLT (G)
| LIFT BRACKET |
| ROD |
5116" NYLOCK | 314"WASHER (BB) |
NUT (V) | 118" x |
| |
| COTTER PIN (O) |
FIGURE 15 |
|