ATTACHING DISCHARGE CHUTE
•Remove the wing knobs from each side of the discharge opening on the
•Using two 7/16" wrenches, remove hex lock nut, two spacers, and the hex bolt from top of the housing assembly. For easy assembly, do not remove the second spacer from the hex bolt.
•Place the discharge chute in position on the discharge opening. Insert hex bolt and spacer through hinge on discharge chute and housing (spacer fits inside of hinge). See figure 3 inset.
Hex Nut
--Hex Bolt
Hinge
Insert the hex bolt (that you earlier removed) from the left through the hole on the hopper and the inlet guide. Insert the hex nut onto the bolt from the other side. See figure 4 inset.
Inlet G_
Hopper Pivot Door
Nu1
Sto:
Discharge Chute
Wing
Knob
tg Knob
Inlet Guide
Hopper
Figure 4
Tighten the bolt to remove all sideplay ( after tightening the bolt, the hopper will pivot up and down). This will secure the hopper assembly to
Figure 3
Place second spacer over hex bolt inside the other half of the hinge. Secure with hex lock nut. Tighten securely.
Secure both sides of discharge chute to housing using wing knobs that you earlier removed. Tighten wing knobs.
ATTACHING HOPPER ASSEMBLY
•Remove the
•Place the hopper assembly on the ground and hold it in the position shown in step 1 in figure 4.
•Holding the hopper, push hopper pivot door down inside the hopper. See figure 4.
•Slide the hopper assembly towards the chipper- shredder housing so that the upper guide on the hopper assembly slides under the stop washer on each side of the inlet guide. See figure 4.
•Align the two holes (one on each side) of the lower hopper with the two holes (one on each side) of the inlet guide.
the inlet guide.
To raise the hopper, hold the hopper by the
1. Lift
2. Pull release bar
Figure 5
•To Iowerthe hopper, hold the hopper by the
should drop down. See figure 5.
The flap control rod is already attached to the hopper at the top. The other end of the rod has to be attached
6