Craftsman 247.775870 owner manual Chipper-Shredder, Engine, Other

Page 16

WARNING: Never store machine with fuel A in the fuel tank inside of building where

fumes may reach an open flame or spark, or where ignition sources are present such as hot water and space heaters, furnaces, clothes dryers, stoves, electric motors, etc.

A yearly check-up by your local Sears service center is a good way to make certain your chipper-shredder will provide maximum performance for the next season.

CHIPPER-SHREDDER

Clean the chipper-shredderthoroughly.

Wipe unit with an oiled rag to prevent rust (use a light oil or silicone).

ENGINE

IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel filter, fuel hose, or tank during storage. Also, experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

Drain the fuel tank.

Start the engine and let it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products

in the fuel tank or permanent damage may

Occur,

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable a/temative in minimizing the formation of fuel gum deposits during storage.

Add stabilizer to gasoline in fuel tank or storage container.

Always follow the mix ratio found on stabilizer container.

Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor.

Do not drain the gas tank and carburetor if using fuel stabilizer. Drain all the oil from the crankcase (this should be done after the engine has been

operated and is stillwarm) and refill the crankcase with fresh oil.

If you have drained the fuel tank, protect the inside of the engine as follows.

Remove spark plug, pour approximately 1/2 ounce (approximately one tablespoon) of engine oil into cylinder and crank slowly to distribute oil.

Replace spark plug.

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems. Store unit in a clean, dry area. Do not store next to corrosive materials, such as

fertilizer.

NOTE: If storing in an unventilated or metal storage shed, be certain to rustproof the equipment by coating with a light oil or silicone.

16

Image 16
Contents Crrftsman Content PlugGeneral Operation Children ServiceYour Responsibility Disconnecting Spark Plug Remove CHIPPER-SHREDDERFrom Carton Loose PartsAttaching Discharge Chute Attaching Hopper AssemblyDischarge Chute Attaching the Chipper Chute Attaching the Catcher BAGTo the stop washer on the inlet guide. See figure WasherMeets Ansi Safety Standards Operating ControlsStopping Engine Primer ButtonGAS and OIL FILL-UP Starting Engine Using Your CHIPPER-SHREDDERPlace the throttle control lever in Fast position UP Cleaning To Lower the Hopper AssemblyGeneral Recommendations Base Paper Filter Pre-Cleaner Engine MaintenanceCustomer Responsibilities Lubrication MufflerCleaning the Flail Screen Pul!the flail screen from inside the housing. SeeSharpening or Replacing the Blades SlotAdjusting Carburetor Engine SpeedEngine CHIPPER-SHREDDEROther Dirty air cleaner Fill tank with clean, fresh fuelSears Craftsman 6.5 H.P. CHIPPER-SHREDDER Model 681-0111 681-0144 712-0429 712-302721 747-0531A 34 714-0149B305 287 Key No. Part No 137120A Carburetor 28//27590696 590601 590697 590698 590699 590700 Description Sears