TO STOP ENGINE
•To stop engine, release operator pres- ence control bar.
TO START ENGINE
NOTE: Due to protective coatings on the engine, a small amount of smoke may be present during the initial use of the product and should be considered normal.
1.To start a cold engine, push primer three (3) times before trying to start. Use a firm push. This step is not usually necessary when starting an engine which has already run for a few minutes.
2.Hold operator presence control bar down to the handle and pull starter handle quickly. Do not allow starter rope to snap back.
NOTE: In cooler weather it may be neces- sary to repeat priming steps. In warmer weather over priming may cause flooding and engine will not start. If you do flood engine, wait a few minutes before attempt- ing to start and do not repeat priming steps.
MOWING TIPS
_, CAUTION: Do not use
blade attachments on your mower. Such attachments are hazardous, will damage your mower and could void your warranty.
•Under certain conditions, such as very tall grass, it may be necessary to raise the height of cut to reduce pushing effort and to keep from overloading the engine and leaving clumps of grass clippings.
It may also be necessary to reduce
ground speed and/or run the lawn mower over the area a second time.
•For extremely heavy cutting, reduce the width of cut by overlapping previously cut path and mow slowly.
•For better grass bagging and most cut- ting conditions, the engine speed should be set in the FAST position.
•Pores in cloth grass catchers can become filled with dirt and dust with use and catchers will collect less grass. To prevent this, regularly hose catcher off with water and let dry before using.
•Keep top of engine around starter clear and clean of grass clippings and chaff. This will help engine air flow and extend engine life.
MULCHING MOWING TIPS
IMPORTANT: For best performance, keep mower housing free of
•The special mulching blade will recut the grass clippings many times and reduce them in size so that as they fall onto the lawn they will disperse into the grass and not be noticed. Also, the mulched grass will biodegrade quickly to provide nutrients for the lawn. Always mulch with your highest engine (blade) speed as this will provide the best recut- ting action of the blades.
•Avoid cutting your lawn when it is wet. Wet grass tends to form clumps and interferes with the mulching action. The best time to mow your lawn is the early afternoon. At this time the grass has dried, yet the newly cut area will not be exposed to direct sunlight.
•For best results, adjust the lawn mower cutting height so that the lawn mower cuts off only the top
it will be necessary to raise the height of cut to reduce pushing effort and to keep from overloading the engine and leaving clumps of mulched grass. For extremely heavy grass, reduce your width of cut by overlapping previously cut path and mow slowly.
MAXI_
•Certain types of grass and grass conditions may require that an area be mulched a second time to completely hide the clippings. When doing a sec-
ond cut, mow across (perpendicular) to the first cut path.
•Change your cutting pattern from week to week. Mow north to south one week
then change to east to west the next week. This will help prevent matting and graining of the lawn.
10