PROBLEM
Engine fails to start
Loss of power; operation erratic.
Engine overheats
Too much vibration
Unit does not discharge
Rate of discharge when chipping slows considerably, or composition of discharged material changes.
POSSIBLE CAUSE(S)
1.Spark plug wire disconnected.
2.Safety switch not contacted.
3.Fuel tank empty, or stale fuel.
4.Fuel
5.Faulty spark plug.
1.Spark plug wire loose
2.Unit running on CHOKE.
3.Blocked fuel line or stale fuel.
. Water or dirt in fuel system.
. Carburetor out of adjustment. 6. Dirty air cleaner.
. Carburetor not adjusted properly.
. Engine oil level low.
Loose parts or damaged impeller.
. Discharge chute (elbow) clogged.
. Foreign object lodged in impeller.
3.
Chipper blades dull.
CORRECTIVE ACTION
. Connect wire to spark plug.
2.Correctly install hose adapter nozzle.
3.Fill tank with clean, fresh fuel.
4.Open fuel
5.Clean, adjust gap or replace.
1.Connect and tighten spark plug wire.
2.Move choke lever to OFF position.
3.Clean fuel line; fill tank with clean
fresh gasoline.
4.Disconnect fuel line at carburetor to drain fuel tank. Refill with fresh fuel.
5.Adjust carburetor.*
6.Service air cleaner.*
1.Adjust carburetor.*
2.Fill crankcase with proper oil.
Stop engine immediately and disconnect spark plug wire. Tighten all bolts and nuts. Make all necessary repairs. If vibration
continues, have unit serviced by an authorized service dealer.
1.Stop engine immediately and disconnect spark plug wire. Clean inside of housing
and discharge chute (elbow).
2.Stop engine immediately and disconnect spark plug wire. Remove lodged object.
3.Empty cart.
Sharpen or replace chipper blades.
*Refer to the engine manual packed with your unit.
NOTE: For repairs beyond the minor adjustments listed above, please contact your nearest authorized service dealer.
20 | Call |
| DO NOT RETURN TO STORE |