Craftsman 247.776350 manual Removing Unit From Carton, Loose Parts In Carton SeeFigure1

IMPORTANT:This unit is shipped without gasoline or oil in the engine, After assembly, see OPERATION section of this manual for proper fuel and engine oil fill- up.

This Chipper Shredder has been completely assembled at the factory, except for the debris collection bag, which is stowed in the chipper chute for shipping.

Pull the spring latch upward and gently pivot the chipper chute down until it clicks into the lock rod. See Figure 2.

Removing Unit From Carton

Remove staples, break glue on top flaps or cut tape at carton end and peel along top flap to open carton.

Remove any loose parts.

Cut down along carton edges and lay carton down flat.

Remove packing material. Lift unit from the rear and discard bottom pad. Roll unit out of carton. Check carton thoroughly for loose parts.

Loose Parts In Carton (SeeFigure1)

One Tamper

One Debris Collection Bag (Not Shown)

One Pair of Safety Glasses (Not Shown)

One 20-oz. Bottle of Engine Oil

One Operator's Manual

Figure 2

Raising the Chipper Chute

shredder without chipper chute lowered into WARNING: Never operate the chipper

the operating position.

For convenience when storing, the chipper chute can be pivoted upward. To do so, proceed as follows:

Pull the lock rod outward and pivot the chipper chute upward until it clicks into the spring latch. See Figure 3.

20-oz. Bottle

of Engine Oil

Tamper

Figure 1

Lowering the Chipper Chute

shredderWARNING:without chipper chute lowered into Never operate the chipper

the operating position.

For shipping reasons, the unit is cartoned with its chipper chute in a raised position.To pivot it downward, into the operating position, proceed as follows:

Latch

Lock Rod"

Figure 3