1. Leave the motor running. | E | F |
5. Trouble-Shooting
GB
7 |
E
2. Hold the cutting head 7 parallel to the ground and tap the filament cassette E of the Turbotrimmer on the ground several times in succession (approx.
3 times) (avoid applying sustained pressure to the Turbotrimmer).
The filament is lengthened automatically. Listen for the audible switching action.
The filament limiter F adjusts the filament to the correct length.
Risk of injury!
Pulling the filament
out of the filament cassette:
Risk of injury from the cutting filament!
VAlways unplug the mains plug of the Turbotrimmer be- fore troubleshooting.
If a filament is drawn into the filament cassette you can pull it out again as described below.
1. Unplug the mains plug.
GB
4. Maintenance
E |
2. | Remove the filament cassette as described under 4. Mainte- |
| nance “Replacing the filament cassette” . |
3. | Press together the plastic ring L on the filament cassette E |
| between your thumb and forefinger. |
Risk of injury! | There is a risk of injury from the cutting filament! | |
| V Always unplug the mains plug of the Turbotrimmer be- | |
| fore carrying out maintenance work! |
|
Risk of injury! | Risk of injury and risk of damage to property! | |
| V Never clean the Turbotrimmer under running water or | |
| with a water jet (in particular a high pressure water jet). | |
Cleaning the cover | The ventilation slots must always |
|
and ventilation slots: | be free of dirt. |
|
| v Remove any grass and dirt from | H |
| the cover G and ventilation slots H |
|
| after each use. | G |
Replacing the filament | Risk of injury! |
|
cassette: | AV Never use metallic cutting elements or replacement | |
parts and accessories not provided by GARDENA.
L |
K |
E |
4. | Draw the plastic ring L with the thumb of the other hand over |
| the side part of the filament cassette E (use a screwdriver |
| if necessary). |
| You can now access the filament that was drawn into the fila- |
| ment cassette. |
5. | Unwind the filament K approximately 10 cm and thread |
it through the eye of the plastic ring L. If ne- | F |
cessary, loosen the filament beforehand |
|
using a screwdriver. The filament K |
|
may stand out max. 2 cm over the |
|
knife F. |
|
6. Pull the plastic ring L back over the filament cassette E.
7. Reinstall the filament cassette as described L under 4.
filament cassette”.
Only GARDENA Service Centres and authorised specialist GARDENA dealers may carry out repairs.
I |
J | J |
E |
K
N 
M |
12
Only use original GARDENA Filament Cassettes. You can order Replacement Filament Cassettes from your GARDENA dealer or directly from the GARDENA Customer Service.
•Filament Cassette for Turbotrimmer powerCut: Art. No.
1. | Unplug the mains plug. |
2. | Turn over the Turbotrimmer and rest it on the rubber buffer |
| of the handle. |
3. | Release the cassette cover I by pressing both locking clips J |
L | and remove the cover. |
4. | Remove the filament cassette E. |
5. | Remove any dirt. |
6. | Pull approximately 5 cm of the filament K out of the new |
| filament cassette E through the hole in the plastic ring L. |
7. | Insert the filament cassette E in the filament cassette holder M |
| so that the filament K is inside the metal case N. |
8. | Fit the cassette cover I on the filament cassette holder M so |
| that you hear both locking clips J click into place. |
When replacing the cover, ensure that the filament is inside the metal case and is not trapped.
vIf the cassette cover I cannot be touched down, turn the filament cassette E to and fro, until the filament cassette E is completely in the filament cassette holder M.
Fault | Possible cause | Remedy |
The Turbotrimmer | Filament worn or too short. | v Lengthen the filament – |
no longer cuts. |
| see 3. Operation “Filament |
|
| feed (Tip mechanism for |
|
| automatic filament feed )”. |
|
|
|
| Filament cassette empty. | v Replace the filament cassette |
|
| – see 4. Maintenance |
|
| “Replacing the filament |
|
| cassette” ). |
|
|
|
| Filament drawn into the | v Pull the filament out of the |
| cassette or stuck together. | filament cassette (see above). |
|
|
|
If you have any other problems please contact the GARDENA Customer Service.
6. Storage
The Turbotrimmer must be stored out of the reach of children.
vStore your Turbotrimmer in a dry place where it is protected from frost.
13