Table 1-4. System Messages (continued)

Message

Causes

Corrective Actions

 

 

 

Plug & Play

Error encountered in

Install the NVRAM_CLR

Configuration Error initializing PCI device;

jumper and reboot the

 

faulty system board.

system. See Figure 6-1 for

 

 

jumper location. Check for

a BIOS update. If the problem persists, see "Troubleshooting Expansion Cards" on page 113. If the problem persists, see "Getting Help" on page 127.

Read fault

Requested sector not found

The operating system cannot read from the diskette or hard drive, the system could not find a particular sector on the disk, or the requested sector is defective.

Replace the diskette. Ensure that the diskette and hard-drive cables are properly connected. See "Troubleshooting a USB Device" on page 102 or "Troubleshooting a Hard Drive" on page 111 for the appropriate drive(s) installed in your system.

Remote

System could not

Retry Remote

Configuration

implement Remote

Configuration.

update attempt

Configuration request.

 

failed

 

 

SATA port 0/1/2

Faulty drive. Parameters

Ensure that the hard drive

hard disk drive

failure.

cables are properly

configuration error

 

connected. See

 

 

"Troubleshooting a Hard

 

 

Drive" on page 111.

 

 

 

SATA port 0/1/2

Faulty drive. INT13 call

Ensure that the hard drive

hard disk drive

failure from the drive.

cables are properly

failure

 

connected. See

SATA port 0/1/2

 

"Troubleshooting a Hard

 

Drive" on page 111.

hard disk drive

 

 

 

auto-sensing error

 

 

26

About Your System

Page 26
Image 26
Dell NM176 System could not Retry Remote, Implement Remote Configuration, Configuration request, Troubleshooting a Hard