Dell NM176 owner manual Installing the Riser Card, Installing and Removing the Riser Card Screws

Figure 3-16. Installing and Removing the Riser Card

1

2

1 screws (2) 2 riser card

Installing the Riser Card

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the computer and protecting against electrostatic discharge.

1Insert the riser card firmly into the riser card connector on the system board until the riser card is fully seated.

2Using a #2 Phillips screwdriver, install the two screws that secure the riser card to the system board.

3Install any expansion card(s). See "Installing an Expansion Card" on page 75.

4Close the system. See "Closing the System" on page 55.

80

Installing System Components