Dell NM176 System is incorrectly, Configured, Faulty or improperly Ensure that all memory, Device

Table 1-4. System Messages (continued)

Message	Causes	Corrective Actions
Manufacturing mode	System is incorrectly
detected	configured.
Memory address line	Faulty or improperly	Ensure that all memory
failure at address,	installed memory modules,	modules are properly
read value	or faulty system board.	installed. See
expecting value		"Troubleshooting System
Memory double word		Memory" on page 108. If
		the problem persists, see
logic failure at
		"Getting Help" on
address, read value
		page 127.
expecting value
Memory odd/even
logic failure at
start address to
end address
Memory write/read
failure at address,
read value
expecting value
Memory tests	The spacebar was pressed	Information only.
terminated by	during POST to terminate
keystroke	the memory test.
No boot device	The system cannot find the	If the diskette drive is your
available	diskette or hard drive.	boot device, ensure that a
		bootable disk is in the drive.
		If the hard drive is your
		boot device, ensure that the
		hard drive is installed,
		properly seated, and
		partitioned as a boot
		device.
		Enter the System Setup
		program and verify the boot
		sequence information. See
		your Hardware Owner’s
		Manual for details.

About Your System

23