Craftsman 247.388240 owner manual Gas And Oil Fill-Up, Starting Engine

Page 10

Stopping Engine

Release blade controlhandle to stop the engine and the blade.

Disconnect spark plug wire and move away from spark plug to prevent accidental starting.

again refer to the safety rules on pages 3-5 WARNING: Before using your lawn mower, of this manual. Always be careful.

Gas And Oil Fill-Up

Engine Oil

Only use high quality detergent oil rated with API service classification SF, SG or SH. Select the oil's

viscosity grade according to your expected operating temperature. Follow the chart below.

Colder _ 3:°F"_ Warmer

"_- 5W30 l SAE30 ---

Oil Viscosity Grade Chart

Use SAE3O oU; do not use 10W40 oil.

Fill oil sump and checkthe oillevel as follows:

a.Positionthe mower on level ground.

b.Clean area around oil fill plug.

C.Remove oilfill plug and dipstick.

d.Wipe dipstick clean, insert it into oil fill hole and tighten securely.

e.Remove dipstickand check oil level. If the oil is not uptoFULL mark on the dipstick, pour recommended oil through the oil fill and check the level again.

Install oil fill plug and dipstick,tighten securely.

NOTE: Although multi-viscosityoils (5W30, 10W30, etc.) improve starting in cold weather, these multiviscosity oils will resultin increased oil consumption when used above 32°F. Check the oil level more frequently to avoid possible engine damage from runninglow on oil.

Gasoline

when engine is runningor hot. Do not WARNING: Never fill fuel tank indoors, or

smoke when filling fuel tank.

Clean area around gas tank cap. For location, see Figure 10. Remove cap.

Use a funnel to prevent spillage.

Pour approximately 1.5 quads of fresh, regular grade, unleaded gasoline slowly to the fuel tank.

IMPORTANT: Never mix engine oil with gasoline. Fill tank to 1/2" below the bottom of the filler neck. Wipe any fuel spillage. Do not fill fuel tank completely. Provide space for fuel expansion.

Starting Engine

(Refer to Figure 11.)

operator is standing near the lawn mower

WARNING: Be sure no one other than the while starting or operating.

Attach spark plug wire to spark plug. Make certain the metal cap on the end of the spark

plug wire is fastened securely over the metal tip on the spark plug.

&enclosed, poorly ventilated areas. Engine exhaust contains carbon monoxide, an ododass and deadly gas.WARNING: Never run engine indoors or in

WARNING: Keep hands, feet, hair and loose clothing away from any moving parts on engine and lawn mower.

Push primer three times. Wait about two seconds between each push. In cold weather

around 55 ° F or below, prime five times. Do not

prime to restart a warm engine after a short shutdown.

Hold control handle against the upper handle. Grasp recoil starter and pull rope out slowly until engine reaches the start of compression cycle (rope will pull slightlyharder at this point). See Figure 11 inset. Let the rope rewind slowly.

Hold handles firmly

Pull recoil starter

Check/fill_

Fill gasoline

Attach s

3 times

plug wire

 

Figure 11

10

Image 10
Contents Craftsmrn Sears, Roebuck & Co., Hoffman Estates, IL 60179, U.S.AProduct Specifications General Operation Slope Operation ServiceChildren Your Responsibility Siavertichtanoho or a TR Loose Pads Disconnecting Spark PlugRemoving Unit From Carton Assembling HandleAssembling Grass Catcher Attaching Starter RopeAttaching Discharge Chute Attaching Grass Catcher to MowerMeets Cpsc Blade Safety Standards Know Your Lawn MowerGas And Oil Fill-Up Starting EngineUsing Grass Catcher Using Your Lawn MowerHeight Adjustment General Recommendations CleaningEngine Maintenance Ustomer ResponsibilitiesTo Change Engine Oil Blade Care LubricationEngine Adjustments Servicing BladeAdjusting Handle Height Adjusting Cutting HeightEngine MowerOther Problem Possible Cause Sears Craftsman 4.0 H.P. Lawn Mower Model 731-1405 300 This en inecouldhavebeenbuittwith590694starter Carburetor No Recoil Starter Part