Orion G42110 owner manual High Level Harnesses, Amplifier Settings

Page 6

HIGH LEVEL HARNESSES

Do not connect the high level input connections to power, signal, or chassis ground as damage to the head-unit outputs may result.. The high-level inputs are designed to work with either grounded or BTL speaker level outputs (found on most head units)..

HIGH LEVEL CONNECTIONS

WIRE COLOR

INPUT CONNECTION

 

 

Black

Ground

 

 

White

+ Left Front channel

 

 

White/Black

- Left Front channel

 

 

Green/Black

- Right Rear channel

 

 

Green

+ Right Rear channel

 

 

Gray

+ Right Front channel

 

 

Gray/Black

- Right Front channel

 

 

Violet/Black

- Left Rear channel

 

 

Violet

+ Left Rear channel

 

 

Amplifier Settings

Signal Input and Output Configurations

The input section of the amplifier consists of a 2 CH / 4 CH switch that sets the output configura- tion, gain controls, and RCA inputs.. The input section makes it easy to adapt this amplifier to most system configurations..

Input Gain

The Orion Cobalt CO600..4 amplifiers have level adjustments to allow for easy integration with any source unit.. The input sensitivity can be adjusted from 250mV to 5V.. Refer to Testing the System and Adjusting the Sound of the System sections of this guide for detailed instructions on setting the gain..

Internal Crossover

The crossover section of the Orion Cobalt CO600..4 amplifiers is continuously variable and extremely flexible..

When using Orion Cobalt loudspeakers, minor deviations from the recommended frequency ranges can provide superior results depending on your speaker locations and your vehicle acoustics.. Setting crossover frequencies higher than recommended will not cause damage and may provide superior sonic results depending on your system's performance goals.. Refer to your loudspeaker owner's manual for assistance in choosing the proper crossover frequencies for your system..

Low-Pass Crossover

The low-pass crossover is active with a 2nd order (12dB per octave) slope.. The low-pass crossover is continuously variable from 50Hz to 500Hz..

© 2007 directed electronics—all rights reserved

5

Image 6
Contents Amplifier Table of Contents Introduction WHAT’S in the BOXPractice Safe Sound Tools of the Trade End Panel LayoutsInput Plate CEA Specifications Output PlateAmplifier Settings High Level HarnessesSpeaker Wiring Diagram CO600.4 Amplifier WiringPower Connections for the Orion Cobalt CO600.4 High-Pass CrossoverBridging Amplifier InstallationTri-mode Choosing Mounting LocationsGeneral Precautions and Installation Tips Step By Step InstallationTrunk Compartment Set Up and Troubleshooting Testing the SystemAdjusting the Sound of the System Troubleshooting Tips Symptom Probable Cause Action To TakeSymptom Probable Cause Action To Take Specifications Amplifier Section CO600.4Crossover Section Directed electronics-all rights reserved Agencement DES Panneaux Dextrémité Panneau dentrée figurePanneau de sortie figure Spécifications DE Lace Faisceaux À Haut NiveauRéglages DE Lamplificateur Câblage DE Lamplificateur Installation DE Lamplificateur Installation étape par étape Réglage ET Dépannage Essai du systèmeRéglage sonore du système Directed electronics-all rights reserved Conseils de dépannage Symptôme Cause probable FaireDirected electronics-all rights reserved Spécifications Section amplificateur CO600.4Section répartiteur Disposiciones del panel de extremo Placa de entrada figuraPlaca de salida figura Configuraciones del amplificador Especificaciones de la CEAArneses DE Cableado DE Alto Nivel Crossover de pasaaltas Cableado del amplificadorCrossover de pasabajas Modalidad tripleInstalación del amplificador Instalación paso a paso Configuración y detección y reparación de averías Prueba del sistemaAjuste de sonido del sistema Directed electronics-all rights reserved Sugerencias de detección y reparación de averías Síntoma Causa probable Medidas a tomarDirected electronics-all rights reserved Especificaciones Sección de amplificador CO600.4Sección de crossover Layouts der Endabdeckung Anschlussplatte abbildungAusgangsplatte abbildung CEA-DATEN HOCHPEGEL-LEITUNGSSYSTEMEVerstärkereinstellungen Verstärkeranschluss Verstärkerinstallation Schrittweise Installation Einrichtung und Problembehebung SystemtestSystemsound einstellen Directed electronics-all rights reserved Problemlösungen Symptom Mögliche Ursache LösungDirected electronics-all rights reserved Daten Verstärkerbereich CO600.4Crossover-Bereich Layout dei pannelli terminali Pannello d’ingresso figuraPannello di uscita figura Specifiche CEA Cavi DI Livello AltoImpostazioni dell’amplificatore Crossover passa-basso Speaker Wiring Diagram CO600.4 figura 3,4Cablaggio dell’amplificatore Crossover passa-altoInstallazione dell’amplificatore Procedura di installazione Messa a punto e soluzione dei problemi Prova dell’impiantoRegolazione dell’audio dell’impianto Directed electronics-all rights reserved Soluzione dei problemi Sintomo Causa probabile Intervento necessarioDirected electronics-all rights reserved Dati tecnici Sezione amplificatore CO600.4Sezione crossover Layouts dos painéis Painel de entrada figuraPainel de saída figura Ligações DE Alto Nível Configurações de entrada e saída dos sinaisEspecificações da CEA Ajustes do amplificadorConexão dos cabos do amplificador Instalação do amplificador Instalação passo a passo Instalação e resolução de problemas Como testar o sistemaComo ajustar o som do sistema Directed electronics-all rights reserved Sugestões para resolução de problemas Problema Provável causa Medida a ser tomadaReajuste os crossovers.. Consulte as instruções Especificações Seção do amplificador CO600.4Seção do crossover Warranty

G42110 specifications

The Orion G42110 is a robust and versatile unmanned aerial vehicle (UAV) designed primarily for a range of commercial and military applications. Renowned for its advanced capabilities, the G42110 integrates state-of-the-art technologies, making it an ideal choice for surveillance, reconnaissance, and various environmental monitoring efforts.

One of the standout features of the Orion G42110 is its impressive flight endurance. With a maximum range of over 1,000 kilometers and the ability to stay aloft for up to 24 hours, this UAV allows for extended missions without the need for frequent refueling or landings. This extended range positions it as an effective tool for long-duration monitoring operations, whether over land or water.

The G42110 is equipped with a high-performance propulsion system that combines a quiet, fuel-efficient engine with cutting-edge aerodynamics. This technology not only enhances the UAV's maneuverability but also reduces its acoustic signature, enabling discreet operations in sensitive areas. The fuselage design contributes to reduced drag and improved operational efficiency, fostering an optimal blend of speed, stability, and stealth.

In terms of payload capacity, the Orion G42110 can accommodate a variety of sensors and equipment, including electro-optical and infrared cameras, synthetic aperture radar (SAR), and signals intelligence (SIGINT) systems. This adaptability allows operators to customize missions to meet specific needs, whether for search and rescue, disaster response, or agricultural monitoring.

The vehicle's avionics suite is equipped with advanced autopilot systems and flight control technologies that facilitate autonomous operation. Pilots can easily program flight paths, allowing for consistent and repeatable missions. Furthermore, real-time data transmission capabilities enable operators to receive immediate situational awareness and quickly make informed decisions in the field.

Durability is another hallmark of the G42110. Built with high-strength composite materials, the UAV is designed to withstand harsh environmental conditions, ensuring reliable performance even in challenging weather scenarios. Its rugged construction enhances its longevity and reduces maintenance costs.

In summary, the Orion G42110 stands out as a versatile UAV that combines long endurance, advanced technologies, and adaptability to various mission profiles. With its exceptional payload capacity, low-observability features, and autonomy, this unmanned aerial vehicle represents a significant advancement in UAV technology, catering to the needs of diverse sectors from military to civilian applications. As industries continue to explore the possibilities of drones, the Orion G42110 is poised to play a pivotal role in modern aerial operations.