Symmetricom 5402, 5401 manual Burst Status On, Burst Status Off, Status will be output every second

Page 22

Operating Manual

Operation

Burst Status On

Command Format:

Description:

Status will be output every second.

Response Format:

Burst Status Off

Command Format:

Description:

Turns burst status off.

Response Format:

No Response. When burst is on.

When burst is off:

PN 8500-0150, Rev. A, May 2005

14

Image 22

Contents

Airborne Disciplined Rubidium Oscillator Symmetricom, Inc Limited Warranty Operating Manual PrefaceLimitation of Liability Where to Find Answers to Product and Document QuestionsProprietary Notice Conventions Used in This Guide When text appears It means This way Operating Manual Preface Typographical ConventionsOperating Manual Contents PN 8500-0150, Rev. A, May Contents-1Specifications Operating ManualProduct Overview Operating Manual IntroductionSymmetricom 5401 Airborne Disciplined Rubidium Oscillator Symmetricom 5402 Disciplined Rubidium OscillatorOperating Manual Installation InstallationSymmetricom 5401 Installation Procedure Unpacking and InspectionSymmetricom 5401 Adjustments 5401 Adjustment LocationsSymmetricom 5402 Rack Mounting Procedure Symmetricom 5402 Adjustments Symmetricom 5402 Installation ProcedureSymmetricom 5402 Initial Operation RS-232 Input/Output Operating Manual OperationOperating Manual Operation DRO Commands Via RS-232 Status RequestDiscipline Off Description Discipline On Dynamic Gain ControlEnter KO1, KO2 Enter KMMinutes Enter Disgain Enter Resync ThresholdEnter Resync Delay Enter Rate ThresholdStatus will be output every second Burst Status OnBurst Status Off Turns burst status offDRO Discipline Sequence Flowchart Request TIRequest Firmware Version Enter DAC ValueDTyyy Firmware Number PN 8500-0150, Rev. A, May Request Start-up Parameters Enter Start-up ParametersOperating Manual Operation Revision Letter of Firmware Calibrate Unit Response Format DescriptionSet Defaults Returns the unit to a default state Default ValuesRequest Setup Parameters Enter 1 PPS Offset not implementedInput Threshold High/Low Enter Programmable Delay Value Enter Oscillator Control Range not implementedDesign Verify On/Off Cal Status Enter Estimation Filter Time ConstantEnter Dynamic Gain Factors Operating Manual Specifications Input Specifications and CharacteristicsInput Specifications and Characteristics Output Specifications and Characteristics Output Specifications and CharacteristicsCoherence a 5402 Indicators Front Panel Indicators Front Panel5401 Indicators Front Panel DRO Internal Time BasesMHz Oven Oscillator Operating Manual Specifications DRO Internal Time Bases10 MHz Oven Oscillator Approximately 8 pounds DimensionsWeight Approximately 10 pounds PN 8500-0150, Rev. A, MayEnvironment EMI