Weed Eater 530163993 General Recommendations, Check for Loose Fasteners and Parts

D Move slowly back and forth over the material as you vacuum. Avoid forcing the unit into a pile of debris as this can clog the unit.

D Keep the vacuum tube about an inch above the ground for best results.

WARNING: If the unit becomes clogged, stop the unit and unplug the ex- tension cord. Wait until the impeller has completely stopped turning, then remove the vacuum tubes. Carefully reach into the vacuum opening and clear out the clogged debris.

WARNING: Disconnect power source before performing maintenance.

GENERAL RECOMMENDATIONS

The warranty on this unit does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, the operator must main- tain unit as instructed in this manual. Vari- ous adjustments will need to be made peri- odically to properly maintain your unit.

BEFORE EACH USE

CHECK FOR LOOSE FASTENERS AND PARTS

SInlet Cover S Blower Tube

S Vacuum Tubes S Collection Bag

CHECK FOR DAMAGED OR

WORN PARTS

Contact an authorized service dealer for replacement of damaged or worn parts.

SON/OFF Switch -- Ensure switch functions properly by moving the switch to the OFF

position. Make sure motor stops; then re- start motor and continue.

SInlet Cover -- Discontinue use of unit if in- let cover fails to latch properly or if it is damaged in any way.

AFTER EACH USE

INSPECT AND CLEAN UNIT & LABELS

Stop unit and unplug extension cord.

SAfter each use, inspect complete unit for loose or damaged parts. Clean the unit using a damp cloth with a mild detergent.

SWipe off unit with a clean dry cloth.

CLEAN COLLECTION BAG IMPORTANT: THE COLLECTION BAG MUST BE PROPERLY EMPTIED.

D You must properly empty and maintain the collection bag to avoid deterioration and obstruction of air flow.

8

DRemove the collection bag from the unit and empty after each use. Do not store bag without emptying the bag of all con- tents (grass, leaves, etc.).

DWash the bag once a year. Remove the bag from the blower and turn the bag in- side out. Wash the bag with a water hose. Allow the bag to hang and dry completely before you reuse the bag.

HOW TO REMOVE AN OBJECT FROM THE AIR INTAKE

WARNING: Stop the unit and dis- connect from the power source before opening the inlet cover. The motor must be stopped and the impeller blades no longer turning to avoid serious injury from the rotating blades.

SWhile holding the inlet cover open, re- move the vacuum tubes. The inlet cov- er must be held open through all re-

maining steps.

SCarefully reach into the vacuum open- ing and clear out the air intake area.

Clear all debris from impeller.

S Inspect the impeller for cracks. If cracked or damaged, do not use the unit. Have parts replaced by your au- thorized service dealer. Do not attempt to replace them yourself.

WARNING: Perform the following steps after each use:

SStop unit and disconnect from the power source.

S Allow motor to cool before storing or transporting.

SStore unit with all guards in place. Posi-

tion unit so that any sharp object cannot accidentally cause injury.

S Store unit unplugged, well out of the reach of children.

SEASONAL STORAGE

Prepare unit for storage at the end of the season or if it will not be used for 30 days or more.If your blower is to be stored for a period of time:

SStop unit and disconnect from the power source.

SClean the entire unit before lengthy stor- age.

S Open inlet cover and clean any dirt, grass, or debris that has collected. In- spect the blower and all tubes. Close and make sure the cover is latched.