D Move slowly back and forth over the material as you vacuum. Avoid forcing the unit into a pile of debris as this can clog the unit.
D Keep the vacuum tube about an inch above the ground for best results.
WARNING: If the unit becomes clogged, stop the unit and unplug the ex- tension cord. Wait until the impeller has completely stopped turning, then remove the vacuum tubes. Carefully reach into the vacuum opening and clear out the clogged debris.
MAINTENANCE
WARNING: Disconnect power source before performing maintenance.
GENERAL RECOMMENDATIONS
The warranty on this unit does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, the operator must main- tain unit as instructed in this manual. Vari- ous adjustments will need to be made peri- odically to properly maintain your unit.
BEFORE EACH USE
CHECK FOR LOOSE FASTENERS AND PARTS
SInlet Cover S Blower Tube
S Vacuum Tubes S Collection Bag
CHECK FOR DAMAGED OR WORN PARTS
Contact an authorized service dealer for replacement of damaged or worn parts. S ON/OFF Switch
start motor and continue.
S Inlet Cover
AFTER EACH USE
INSPECT AND CLEAN UNIT & LABELS Stop unit and unplug extension cord.
SAfter each use, inspect complete unit for loose or damaged parts. Clean the unit using a damp cloth.
SWipe off unit with a clean dry cloth.
CLEAN COLLECTION BAG IMPORTANT: THE COLLECTION BAG MUST BE PROPERLY EMPTIED.
D You must properly empty and maintain the collection bag to avoid deterioration and obstruction of air flow.
D Remove the collection bag from the unit and empty after each use. Do not store
8
bag without emptying the bag of all con- tents (grass, leaves, etc.).
DWash the bag once a year. Remove the bag from the blower and turn the bag in- side out. Wash the bag with a water hose. Allow the bag to hang and dry completely before you reuse the bag.
SERVICE
HOW TO REMOVE AN OBJECT FROM THE AIR INTAKE
WARNING: Stop the unit and dis- connect from the power source before opening the inlet cover. The motor must be stopped and the impeller blades no longer turning to avoid serious injury from the rotating blades.
SWhile holding the inlet cover open, re- move the vacuum tubes. The inlet cov- er must be held open through all re- maining steps.
SCarefully reach into the vacuum open- ing and clear out the air intake area.
Clear all debris from impeller.
S Inspect the impeller for cracks. If cracked or damaged, do not use the unit. Have parts replaced by your au- thorized service dealer. Do not attempt to replace them yourself.
STORAGE
WARNING: Perform the following steps after each use:
SStop unit and disconnect from the power source.
S Allow motor to cool before storing or transporting.
S Store unit with all guards in place. Posi- tion unit so that any sharp object cannot accidentally cause injury.
S Store unit unplugged, well out of the reach of children.
SEASONAL STORAGE
Prepare unit for storage at the end of the season or if it will not be used for 30 days or more.If your blower is to be stored for a period of time:
SStop unit and disconnect from the power source.
SClean the entire unit before lengthy stor-
age.
S Open inlet cover and clean any dirt, grass, or debris that has collected. In- spect the blower and all tubes. Close and make sure the cover is latched.
SClean air vents and air inlet of debris.