BLOWER ASSEMBLY
S Insert the blower tube into the blower outlet.
STwist the blower tube clockwise until it is
firmly seated in the blower outlet.
S Twist the nozzle into the end of the blower tube until it is firmly seated. Make sure the nozzle points upward.
Blower outlet
Blower Tube Nozzle
For Model 2695 only, the blower exten- sion tube and nozzle are combined into one component.
Blower Tube/Nozzle
ATTACH VACUUM TUBES
SOn some units an arrow on the tube and the unit will help you align the tube be-
fore twisting clockwise.
S Some units may include locking tabs. These tabs guide and lock the tubes into position.
Once the upper tube is secure on the unit, and cannot be turned clockwise further, the lower vacuum tube may be installed onto the upper tube.
Not all unit will have arrows Arrow
Arrow |
Upper Lower
tube tube
VACUUM ASSEMBLY | ATTACH VACUUM BAG |
(Some models) | Slide the vacuum bag over the blower |
OPEN THE LATCH | outlet as shown. Secure the bag to the |
Insert a screwdriver in to the latch area on | blower outlet by placing the strap through |
the vacuum inlet cover. Gently tilt handle | the metal ring. Pull tight and fasten as |
of screwdriver toward the front of the | shown. Make sure the blower outlet is |
blower to release the latch. Pull up on the | pushed far into the bag before tightening |
vacuum inlet cover with your other hand. | the strap. Some units may include elastic |
| on bag without metal ring. |
Impeller | Latch | Strap |
| Area | |
| Metal Ring | |
|
|
| Vacuum |
|
|
|
|
| Bag |
| Blower Outlet |
| |
Locking Tabs |
|
|
| ||
D Carefully | loop | the | shoulder | strap | |
REMOVE THE INLET RESTRICTOR through the buckle as shown.
(Some models) | Last In |
An inlet restrictor is used when operating your unit as a blower. This restrictor is not
used during vacuum operation and must First In be removed during vacuum assembly.
Once the cover is opened, look for the in- let restrictor between the door and the im- peller.
D Remove the inlet restrictor by rotating
counterclockwise (see illustration). D Position the unit on your
Keep this inlet restrictor for use when | side, blower outlet and bag pointing to- |
using your unit as a blower later. With | ward the rear. Hold the unit in an upright |
the restrictor removed, the upper vacu- | position, and support the lower vacuum |
um tube will twist onto the unit. | tube on the ground. |
5