WARNING: Perform the following steps after each use:
SStop unit and disconnect from the power
source.
S Allow motor to cool before storing or transporting.
SStore unit with all guards in place. Posi- tion unit so that any sharp object cannot accidentally cause injury.
S Store unit unplugged, well out of the reach of children.
SEASONAL STORAGE
Prepare unit for storage at the end of the season or if it will not be used for 30 days or more.If your blower is to be stored for a period of time:
SStop unit and disconnect from the power source.
SClean the entire unit before lengthy stor- age.
TROUBLESHOOTING TABLE
S Open inlet cover and clean any dirt, grass, or debris that has collected. In- spect the blower and all tubes. Close and make sure the cover is latched.
SClean air vents and air inlet of debris.
S Store your unit and extension cord in a well ventilated area and covered, if pos- sible, to prevent dust and dirt accumula- tion. Do not cover with plastic. Plastic can- not breathe and may cause condensation and eventual rust or corro- sion.
S Check entire unit for loose screws. Re- place any damaged, worn, or broken parts.
Need Accessories or Assistance? Call:
Need Service Parts?
Contact your dealer.
ACCESSORIES AVAILABLE
Safety Goggles Stock #952701506 Flex Vac Kit FV1910 #952701627 (used only on model 2540 and 2560)
WARNING: Always stop unit and disconnect from the power source before performing all of the recommended remedies below except remedies that re- quire unit to be operating.
SYMPTOM |
| CAUSE |
| REMEDY | |
|
| ||||
Unit fails to |
| 1. | Switch in the OFF position. | 1. | Slide switch to ON position. |
operate. |
| 2. | Extension cord | 2. | Reconnect extension cord. |
|
|
| nected. | 3. | Reset circuit breaker or |
|
| 3. | Circuit breaker tripped, or | ||
|
|
| fuse blown. |
| fuse. |
|
| 4. | Mechanical failure | 4. | Contact your authorized |
|
|
|
|
| service dealer. |
|
|
|
| ||
Unit |
| 1. Mechanical failure | 1. Contact your authorized | ||
vibrates |
|
|
|
| service dealer. |
abnormally. |
|
|
|
|
|
|
|
|
| ||
Impeller will |
| 1. Debris in air intake area. | 1. Clean unit. Remove any | ||
not turn free- |
| 2. Mechanical failure. |
| debris. | |
ly. |
|
|
| 2. Contact your authorized | |
|
|
|
|
| service dealer. |
|
|
|
|
|
|
8