Weed Eater 2600 manual Cisco High-Density Analog Voice and Fax Network Module

Page 1

Cisco High-Density Analog Voice and Fax Network Module

Feature History

Release

Modification

 

 

12.2(2)XT

These features were implemented on the Cisco 2600 series, Cisco

 

3640 and the Cisco 3660 router.

 

 

12.2(8)T

This feature was integrated into Cisco IOS Release 12.2(8)T.

 

 

This document describes the Cisco High-Density Analog Voice and Fax Network Module (NM-HDA) in Cisco IOS Release 12.2(8)T. This document includes the following sections:

Feature Overview, page 2

Supported Platforms, page 9

Supported Standards, MIBs, and RFCs, page 10

Prerequisites, page 10

Configuration Tasks, page 11

Configuration Examples, page 29

Command Reference, page 31

Glossary, page 37

Cisco IOS Release 12.2(2)XT and 12.2(8)T

1

Image 1
Contents Cisco High-Density Analog Voice and Fax Network Module Feature History Release ModificationBase Module Feature OverviewVoice Port Numbers InterfaceFXS and FXO Interfaces Telephony Signaling InterfacesDisconnect Supervision Commands Delay in Voice Networks FXO Supervisory Disconnect Tone CommandsEcho Cancellation Voice Level AdjustmentAdaptive Jitter Buffering Serviceability Voice Activity Detection CommandsBenefits Cost EffectiveSupported High-Complexity Codecs RestrictionsSupported Medium-Complexity Codecs Supported low-Complexity CodecsRelated Documents Supported PlatformsCisco 2600 series Prerequisites Supported Standards, MIBs, and RFCsConfiguring Analog FXO and FXS Voice Ports Configuration TasksCommand Purpose FXO or FXSDefault is Keyword default is 25 on Cisco 2600 seriesDefault is the pattern specified by the cptone Locale that has been configuredFine-Tuning Analog Voice Ports Configuring Voice Activity Detection VADConfiguring Disconnect Supervision Commands Reversal is enabled Enables battery reversal. The default is that batteryFor FXO ports-Use the no battery-reversal Command to configure a loop-start voice port to notConfiguring FXO Supervisory Disconnect Tone Commands Sec. The default is From 0 to 1000 0 ms to 10 sec. The default isExits voice class configuration mode Voice network module is installedConfiguring Timeouts Commands Timing Commands Configuring Adaptive Jitter Adjustment Voice Quality Tuning CommandsConfiguring Voice Level Adjustment Configuring Echo AdjustmentPlatform Command Syntax Verifying Analog Voice-Port ConfigurationsTroubleshooting Chart, Voice Port Testing Commands, Troubleshooting TipsProblem Suggested Action Troubleshooting ChartReconfigure the voice port Keyword setting also called region tone is USConfiguring Voice Level Adjustment section on Voice Port Testing CommandsLoopback Function Tests Detector-Related Function TestsRelay-Related Function Tests Tone Injection TestsKeyword fax to force the voice port into fax mode Fax/Voice Mode TestsTest. Enter the keyword disable to return Voice port to voice modeAnalog FXO Voice Port Example Configuration ExamplesAnalog FXS Voice Port Example Debug dspapi, Debug hpi, Command ReferenceDebug dspapi Defaults Command Modes Command HistorySyntax Description Release ModificationRelated Commands Description Command Modes Command History DefaultsDebug hpi Usage Guidelines ExamplesTo global configuration mode Global configurationVoice-port Cisco 2600, and Cisco 3600 RouterEncapsulation Dial-peer voiceGlossary
Related manuals
Manual 9 pages 15.51 Kb