Weed Eater 2600 manual Timing Commands

Cisco High-Density Analog Voice and Fax Network Module

Configuration Tasks

Timing Commands

To change timing parameters, use the following commands as appropriate, in voice-port configuration mode:

	Command	Purpose
Step 1
	Router(config-voiceport)#timing dial-pulse min-delay	Specifies time, in milliseconds, between the
	milliseconds	generation of wink-like pulses when the type is
		pulse. Valid entries are from 0 to 5000. The default
		is 300 for the Cisco 3600 series routers.
Step 2
	Router(config-voiceport)# timing digit milliseconds	Specifies the DTMF digit signal duration in
		milliseconds. Valid entries are from 50 to 100. The
		default is 100.
Step 3
	Router(config-voiceport)# timing guard-out	(FXO ports only) Specifies the duration in
	milliseconds	milliseconds of the guard-out period that prevents
		this port from seizing a remote FXS port before the
		remote port detects a disconnect signal. The range
		is from 300 to 3000. The default is 2000.
Step 4
	Router(config-voiceport)# timing hookflash-out	Specifies the duration, in milliseconds, of the
	milliseconds	hookflash. Valid entries are from 50 to 500. The
		default is 300.
Step 5
	Router(config-voiceport)# timing interdigit	Specifies the DTMF interdigit duration, in
	milliseconds	milliseconds. Valid entries are from 50 to 500. The
		default is 100.
Step 6
	Router(config-voiceport)# timing pulse	(FXO only) Specifies the pulse dialing rate in
	pulses-per-second	pulses per second. Valid entries are from 10 to 20.
		The default is 20.
Step 7
	Router(config-voiceport)# timing pulse-digit	(FXO only) Configures the pulse digit signal
	milliseconds	duration. The range of the pulse digit signal
		duration is from 10 to 20. The default is 20.
Step 8
	Router(config-voiceport)# timing pulse-interdigit	(FXO only) Specifies pulse dialing interdigit
		timing in milliseconds. Valid entries are from 100
		to 1000. The default is 500.

Cisco IOS Release 12.2(2)XT and 12.2(8)T

19