Weed Eater 2600 manual Detector-Related Function Tests, Loopback Function Tests

Cisco High-Density Analog Voice and Fax Network Module

Configuration Tasks

Detector-Related Function Tests

Using the test voice port detector command, you are able to force a particular detector into an on or off state, perform tests on the detector, and then return the detector to its original state.

To configure this feature, use the following commands in privileged EXEC mode:

	Command	Purpose
Step 1
	Router# test voice port slot/subunit/port detector	Identifies the voice port you want to test. Enter a
	{m-lead battery-reversal loop-current ring	keyword for the detector under test and specify
	tip-ground ring-ground ring-trip} {on off}	whether to force it to the on or off state.
		Note For each signaling type (FXO, FXS), only
		the applicable keywords are displayed.
		The disable keyword is displayed only
		when a detector is in the forced state.
Step 2
	Router# test voice port slot/subunit/port detector	Identifies the voice port on which you want to end
	{m-lead battery-reversal loop-current ring	the test. Enter a keyword for the detector under
	tip-ground ring-ground ring-trip}disable	test and the keyword disable to end the forced
		state.
		Note For each signaling type (FXO, FXS), only
		the applicable keywords are displayed.
		The disable keyword is displayed only
		when a detector is in the forced state.

Loopback Function Tests

To establish loopbacks on a voice port, use the following commands in privileged EXEC mode:

	Command	Purpose
Step 1
	Router# test voice port slot/subunit/port loopback	Identifies the voice port you want to test and enters
	{local network}	a keyword for the loopback direction.
		Note A call must be established on the voice
		port under test.
Step 2
	Router# test voice port slot/subunit/port loopback	Identifies the voice port on which you want to end
	disable	the test and enters the keyword disable to end the
		loopback.

Cisco IOS Release 12.2(2)XT and 12.2(8)T

26