Weed Eater 2600 manual Analog FXS Voice Port Example

Page 30

Cisco High-Density Analog Voice and Fax Network Module

Configuration Examples

Analog FXS Voice Port Example

The following example shows analog FXS output for voice-port configuration:

voice-port 1/0/0 signal loopStart no vad

station-id name test1 abc station-id number 8000 caller-id enable

voice-port 1/0/1 signal loopStart no vad

voice-port 1/0/2 signal loopStart no vad

voice-port 1/0/3 signal loopStart no vad

Cisco IOS Release 12.2(2)XT and 12.2(8)T

Image 30

Contents Feature History Release Modification Cisco High-Density Analog Voice and Fax Network ModuleVoice Port Numbers Feature OverviewBase Module InterfaceTelephony Signaling Interfaces FXS and FXO InterfacesDisconnect Supervision Commands FXO Supervisory Disconnect Tone Commands Delay in Voice NetworksVoice Level Adjustment Echo CancellationAdaptive Jitter Buffering Benefits Voice Activity Detection CommandsServiceability Cost EffectiveSupported Medium-Complexity Codecs RestrictionsSupported High-Complexity Codecs Supported low-Complexity CodecsSupported Platforms Related DocumentsCisco 2600 series Supported Standards, MIBs, and RFCs PrerequisitesCommand Purpose Configuration TasksConfiguring Analog FXO and FXS Voice Ports FXO or FXSDefault is the pattern specified by the cptone Keyword default is 25 on Cisco 2600 seriesDefault is Locale that has been configuredConfiguring Voice Activity Detection VAD Fine-Tuning Analog Voice PortsConfiguring Disconnect Supervision Commands For FXO ports-Use the no battery-reversal Enables battery reversal. The default is that batteryReversal is enabled Command to configure a loop-start voice port to notConfiguring FXO Supervisory Disconnect Tone Commands Exits voice class configuration mode From 0 to 1000 0 ms to 10 sec. The default isSec. The default is Voice network module is installedConfiguring Timeouts Commands Timing Commands Voice Quality Tuning Commands Configuring Adaptive Jitter AdjustmentConfiguring Echo Adjustment Configuring Voice Level AdjustmentVerifying Analog Voice-Port Configurations Platform Command SyntaxTroubleshooting Tips Troubleshooting Chart, Voice Port Testing Commands,Reconfigure the voice port Troubleshooting ChartProblem Suggested Action Keyword setting also called region tone is USVoice Port Testing Commands Configuring Voice Level Adjustment section onDetector-Related Function Tests Loopback Function TestsTone Injection Tests Relay-Related Function TestsTest. Enter the keyword disable to return Fax/Voice Mode TestsKeyword fax to force the voice port into fax mode Voice port to voice modeConfiguration Examples Analog FXO Voice Port ExampleAnalog FXS Voice Port Example Command Reference Debug dspapi, Debug hpi,Syntax Description Defaults Command Modes Command HistoryDebug dspapi Release ModificationRelated Commands Description Debug hpi DefaultsCommand Modes Command History Usage Guidelines ExamplesVoice-port Global configurationTo global configuration mode Cisco 2600, and Cisco 3600 RouterDial-peer voice EncapsulationGlossary

Related manuals

Manual 9 pages 15.51 Kb