Weed Eater 2600 manual Debug dspapi, Syntax Description, Defaults Command Modes Command History

Cisco High-Density Analog Voice and Fax Network Module

debug dspapi

debug dspapi

To enable debugging for Digital Signal Processor (DSP) Application Programming Interface (API) message events, use the debug dspapi command in EXEC mode. To reset the default value for this feature, use the no form of this command.

debug dspapi { all command detail error notification response }

[no] debug dspapi { all command detail error notification response }

Syntax Description	all	Enables all dspapi debug options (command, detail, error, notification and
		response).
	command	Displays commands sent to the DSPs.
	detail	Displays additional detail for the dspapi debugs enabled.
	error	Displays any dspapi errors.
	notification	Displays notification messages sent from the DSP. (for example, tone
		detection notification).
	response	Displays responses sent by the DSP (for example, responses to statistic
		requests).

Defaults

Command Modes

Command History

This command is not enabled.

EXEC

Release	Modification
12.1(5)XM	This command was first introduced on the Cisco AS5300 and Cisco AS5800.
12.1(5)XM1	This command was implemented on the Cisco AS 5350 and Cisco AS5400.
12.2(2)T	This command was implemented on the Cisco 1700, Cisco 2600 series,
	Cisco 3600 series, and the Cisco 3810.
12.2(8)T	This command was integrated into the Cisco IOS Release 12.2(8)T.

Usage Guidelines DSP API message events used to communicate with DSPs are intended for use with Connexant (Nextport) and Texas Instrument (54x) DSPs. This command severely impacts performance and should be used only for single-call debug capture.

Examples	The following example shows how to enable debugging for all DSP API message events:
	Router #debug dspapi all

Cisco IOS Release 12.2(2)XT and 12.2(8)T

32