Weed Eater 2600 manual Configuring FXO Supervisory Disconnect Tone Commands

Cisco High-Density Analog Voice and Fax Network Module

Configuration Tasks

Configuring FXO Supervisory Disconnect Tone Commands

To create a voice class that defines the specific tone or tones to be detected and then apply the voice class to the voice port, use the following commands beginning in global configuration mode:

	Command	Purpose
Step 1
	Router(config)# voice class dualtone tag	Creates a voice class for defining one tone
		detection pattern. The range for the tag number is
		from 1 to 10000. The tag number must be unique on
		the router.
Step 2
	Router(config-voice-class)# freq-pairtone-id	Specifies the two frequencies, in Hz, for a tone to
	frequency-1 frequency-2	be detected (or one frequency if a nondual tone is
		to be detected). If the tone to be detected contains
		only one frequency, enter 0 for frequency-2. The
		arguments are as follows:
		• tone-id—Ranges from 1 to 16. There is no
		default.
		• frequency-1 and frequency-2—Ranges from
		300 to 3600, or you can enter 0 for
		frequency-2. There is no default.
		Note Repeat this command for each additional
		tone to be specified.
Step 3
	Router(config-voice-class)# freq-max-deviation	Specifies the maximum frequency deviation that
	frequency	will be detected, in Hz. The frequency argument
		ranges from 10 to 125. The default is 10.
Step 4
	Router(config-voice-class)# freq-max-powerdBmO	Specifies the maximum tone power that will be
		detected, in dBmO. The dBmO argument ranges
		from 0 to 20. The default is 10.
Step 5
	Router(config-voice-class)# freq-min-powerdBmO	Specifies the minimum tone power that will be
		detected, in dBmO. The dBmO argument ranges
		from 10 to 35. The default is 30.
Step 6
	Router(config-voice-class)# freq-power-twistdBmO	Specifies the power difference allowed between the
		two frequencies, in dBmO. The dBmO argument
		ranges from 0 to 15. The default is 6.
Step 7
	Router(config-voice-class)# freq-max-delaytime	Specifies the timing difference allowed between
		the two frequencies, in 10-millisecond increments.
		The time argument ranges from 10 to 100 (100 ms
		to 1 sec). The default is 20 (200 ms).
Step 8
	Router(config-voice-class)# cadence-min-on-timetime	Specifies the minimum tone on time that will be
		detected, in 10-millisecond increments. The time
		argument ranges from 0 to 100 (0 ms to 1 sec).
Step 9
	Router(config-voice-class)# cadence-max-off-timetime	Specifies the maximum tone off time that will be
		detected, in 10-millisecond increments. The time
		argument ranges from 0 to 5000 (0 ms to 50 sec).

Cisco IOS Release 12.2(2)XT and 12.2(8)T

16