33.Assemble the hose adapter (nozzle) to the front of the impeller housing and secure with the three knobs. Make sure that the switch actuator bracket contacts the switch on the housing. See figure 19.
HOSE ADAPTER |
(NOZZLE) |
KNOB |
SWITCH |
ACTUATOR |
BRACKET |
FIGURE 19
34.Place a hose clamp onto one end of hose. Push hose onto hose adapter (nozzle). Tighten hose clamp onto hose and hose adapter. Do not collapse hose adapter when tightening clamp. See figure 20.
35.Place the hose hanger rod assembly into the hose hanger bracket on the impeller housing assembly.
See figure 20.
36.Loop the 25" tarp strap under the hose. Hook to the hose hanger rod assembly. See figure 20.
HOSE ADAPTER |
|
(NOZZLE) |
|
HOSE HANGER | HOSE |
ASSEMBLY | |
| CLAMP |
25" TARP |
|
STRAP |
|
FIGURE 20
HINT: Tip the cart bed back for easier access in the next paragraph.
37.Attach the chipper chute assembly to the weld bolts on the back side of the impeller housing using three
5/16" flat washers and 5/16" Nylock nuts. Tighten. See figure 21.
38.Insert the tamper plug into the end of the chipper chute assembly.
CHIPPER CHUTE | |
ASSEMBLY | |
5/16" |
|
NYLOCK | 5/16" FLAT |
NUT | WASHER |
FIGURE 21
39.Assemble the hitch plate to the tractor hitch if:
a.Your tractor has a square (straight) hitch frame, to help prevent binding.
b.Your tractor has a lightweight hitch frame that needs reinforcing for towing the
Use a 1/2" x
1/2" x |
|
HEX BOLT |
|
TRACTOR |
|
HITCH FRAME | ATTACH |
(SQUARE) | |
| HERE |
7/16" FLAT WASHER | HITCH |
PLATE | |
1/2" NYLOCK NUT |
|
TRACTOR |
|
HITCH FRAME |
|
(TAPERED) |
|
FIGURE 22
12