10.5IMPORTANT:
•CHARGE IMMEDIATELY AFTER PURCHASE
•KEEP FULLY CHARGED
Charge the jump starter internal battery immediately after purchase, after every use and every 30 days.
All batteries are affected by temperature. The ideal storage temperature is at 70 degrees Fahrenheit. The internal battery will gradually
11.TROUBLESHOOTING
PROBLEM | POSSIBLE CAUSE | REASON/SOLUTION |
The jump starter won’t jump | Jump Start On/Off switch is | Turn ON the Jump Start On/ |
start my car. | not turned ON. | Off switch. |
| Clips are not making a good | Check for poor connection |
| connection to the battery. | to battery and frame. Make |
|
| sure connection points |
|
| are clean. Rock the clips |
|
| back and forth for a better |
|
| connection. |
| The jump starter battery is | Check the battery charge |
| not charged. | status by pressing the |
|
| button on the front of the |
|
| jump starter. See DIGITAL |
|
| DISPLAY FUNCTIONS |
|
| section of this manual. |
| The vehicle’s battery is | Have the battery checked. |
| defective. |
|
The jump starter won’t | The 12V device is not | Turn on the 12V device. |
power my 12V device. | turned on. |
|
| The jump starter battery is | Check the battery charge |
| not charged. | status by pressing the |
|
| button on the front of the |
|
| jump starter. See DIGITAL |
|
| DISPLAY FUNCTIONS |
|
| section of this manual. |
| The 12V device draws more | Disconnect the 12V device. |
| than 15A or has a short | The internal breaker will |
| circuit | automatically reset after a |
|
| minute or two. Try the 12V |
|
| device again. If it happens |
|
| again, replace the 12V |
|
| device. |
The battery in the jump | The battery is bad (will not | Have the battery checked. |
starter won’t hold a charge. | accept a charge). |
|
The jump starter alarm is | Connections are reversed. | Disconnect the jump starter |
on. |
| and reverse the clips. |
• 9 •