McCulloch ZM4619, 966564101 manual Faulty adjustment can cause an accident, Deck Belt Removal

Page 38

MAINTENANCE

Parking Brake

WARNING!

The machine must be standing absolutely still when the park brake is engaged.

Visually check that no damage is found on the lever, linages, or switch belonging to the parking brake. Perform a stand still test and check that there is a braking action.

To adjust the parking brake, contact the McCulloch service workshop.

WARNING!

Faulty adjustment can cause an accident.

8058-080-1

Released parking brake

Deck Belt

Check every 100 hours of operation. Check for severe cracking and large nicks.

NOTE: The belt will show some small cracks in normal operation.

The belts are not adjustable. Replace belts if they begin to slip from wear.

Deck Belt Removal

1.Park on a level surface. Apply parking brake.

2.Lower the deck into the lowest cutting position.

3.Remove bolts from belt shields and remove shields.

4.Remove any dirt or grass that may have accumulated around the cutter housings and entire deck surface.

5.Loosen the nut securing the belt guide. Note the position of the belt guide for reinstallation.

6.Carefully roll the belt over the top of the cutter housing pulleys and remove belt from the deck.

 

1

 

2

3

1

 

 

8058-107

1.Belt shields

2.Belt guide

3.Idler arm

Removing the deck belt

38

Image 38
Contents Operator Manual Page Table of Contents Page Introduction Good Service Manufacturing NumberSymbols and decals Manual Performing any General Operation SafetySafety Instructions Never take passengers Personal Safety Equipment Slope OperationChildren Safe Handling of Gasoline General Maintenance Risk of sparking Transport Spark ArrestorControls Control LocationsMotion Control Levers Unlocking Transmission Seat Adjustment LeverBypass Linkage Fuel Tank Throttle Control Ignition SwitchChoke Control Parking Brake Blade SwitchCutting Height Adjuster Always use the high position to transportFuses Fuel Shut Off ValveTraining SteeringBefore Starting Starting the EnginePlace controls in neutral position USE Full Throttle When Mowing Weak Battery To remove cables, reverse orderMower deck’s anti-scalp rollers should be evenly adjusted RunningOperating On Hills Mowing Tips Stopping the Engine Manual Transport Maintenance Maintenance ScheduleBefore After Year 100 Battery Replacing batterySafety System Tire PressuresDeck Belt Removal Faulty adjustment can cause an accidentDeck Belt Pump Belt Deck Belt InstallationEZT Belt Installation Replacing EZT E-Series Zeroturn Transaxle beltAnti-scalp Rollers Blade replacementCutting Blades Adjusting the Mower Deck Deck LevelingCaster Wheels CleaningUse protective glasses when cleaning and washing HardwareGeneral LubricationLubrication Schedule Front Wheel Mount Wheel and Deck ZerksDeck Spindles Front Wheel BearingsMaintenance section Trouble ShootingProblem Cause Trouble Shooting Winter Storage ServiceStorage Schematic Hex Head Cap Screws Technical DataTorque Specifications Standard HardwareTransmission ZM4619Engine Productivity Overall dimensionsZM4619 Equipment CE requirements Conformity CertificatesUSA requirements Action Service JournalDelivery Service Stamp, signDaily Service After 10 hoursHour Service Service Journal At least once each year Action Date, mtr reading Stamp, sign Page 115 349428R1 03/08/10